A bridge of this description upon the Baltimore and Ohio Railroad of the following dimensions,

Clear span, 124 feet Length of top chord, 128 feet Length of panel, 15 feet Height of truss, 17 feet Width, 16 feet Lbs. of cast-iron, 65,137 Lbs. of wrought iron, 33,527 Whole weight, 98,664 Weight per lineal foot, 796

Handbook of Railroad Construction — Part 103

Three locomotives with tenders attached, and weighing in all one hundred and twenty-two tons, (nearly one ton per foot,) were run over the bridge at eight miles per hour, when the deflection at centre was one and three eighths inches, and at the first post nine sixteenths of an inch. The following tests were applied to a bridge of seventy-six feet span upon the Washington branch of the same road:

Handbook of Railroad Construction — Part 103

An engine and tender weighing forty tons, caused a deflection of five eighths of an inch. A fast passenger train deflected the bridge nine sixteenths of an inch.

Handbook of Railroad Construction — Part 103

Two engines and tenders, back to back, at rest, and weighing in all 77½ tons, caused a deflection of 11/16 inch, The same at ten miles per hour, 13/16 inch, Engines head to head at four miles per hour, 13/16 inch, Engines head to head at eight miles per hour, 13/16 inch, Engines head to head at twenty miles per hour, 14/16 inch.

The extreme expansion of the one hundred and twenty-eight feet chord from heat, was five sixteenths of an inch at each end, or five eighths of an inch in all, or 1/2457th of the length; and that without the slightest derangement of masonry. The rod C B, being five times as long as C A, expands five times as much, but at the same time the lengths D A, D B, being so nearly proportional to C A, and C B, expand also in the ratio of one to five; and thus no bad result is experienced.

The estimate of strains upon this bridge is extremely simple; the whole consisting of as many separate systems as there are posts. Each set of rods sustain a rectangle equal to one panel, i. e., the two adjacent half panels. Thus A C, and C B, support the rectangle _m m_, _m m_, the rods A F, F B, the rectangle _n n_, _n n_. Allowance must of course be made for the inclination of the rods. The dimensions of the central pair will of course be the same; but those of the other sets will vary. The diagonals D H, and H L, prevent reaction; and must be able to resist the action produced by the variable load upon one panel (as noticed in Chapter VIII).