At length the Newcomen model arrived from London; and in 1763 the little engine, which was destined to become so famous, was put into the hands of Watt. The boiler was somewhat smaller than an ordinary teakettle. The cylinder of the engine was only of two inches diameter and six inches stroke. Watt at first regarded it as merely "a fine plaything." It was, however, enough to set him upon a track of thinking which led to the most important results. When he had repaired the model and set it to work, he found that the boiler, though apparently large enough, could not supply steam in sufficient quantity, and only a few strokes of the piston could be obtained, when the engine stopped. The fire was urged by blowing, and more steam was produced; but still it would not work properly. Exactly at the point at which another man would have abandoned the task in despair, the mind of Watt became thoroughly roused. "Everything," says Professor Robison, "was to him the beginning of a new and serious study; and I knew that he would not quit it till he had either discovered its insignificance or had made something of it." Thus it happened with the phenomena presented by the model of the steam-engine. Watt referred to his books, and endeavored to ascertain from them by what means he might remedy the defects which he found in the model; but they could tell him nothing. He then proceeded with an independent course of experiments, resolved to work out the problem for himself. In the course of his inquiries he came upon a fact which, more than any other, led his mind into the train of thought which at last conducted him to the invention of which the results were destined to prove so stupendous. This fact was the existence of latent heat.
In order to follow the track of investigation pursued by Watt, it is necessary for a moment to revert to the action of the Newcomen pumping-engine. A beam, moving upon a centre, had affixed to one end of it a chain attached to the piston of the pump, and at the other a chain attached to a piston that fitted into the steam-cylinder. It was by driving this latter piston up and down the cylinder that the pump was worked. To communicate the necessary movement to the piston, the steam generated in a boiler was admitted to the bottom of the cylinder, forcing out the air through a valve, where its pressure on the under side of the piston counterbalanced the pressure of the atmosphere on its upper side. The piston, thus placed between two equal forces, was drawn up to the top of the cylinder by the greater weight of the pump-gear at the opposite extremity of the beam. The steam, so far, only discharged the office of the air it displaced; but if the air had been allowed to remain, the piston once at the top of the cylinder could not have returned, being pressed as much by the atmosphere underneath as by the atmosphere above it. The steam, on the contrary, which was admitted by the exclusion of air, _could be condensed_, and a vacuum created, by injecting cold water through the bottom of the cylinder. The piston, being now unsupported, was forced down by the pressure of the atmosphere on its upper surface. When the piston reached the bottom, the steam was again let in, and the process was repeated. Such was the engine in ordinary use for pumping water at the time that Watt began his investigations.