Canada is rich in all the necessaries that are called into play in ship-and yacht-building, the woods she provides for the purpose being some of the finest in the world. Nothing can come up to her timbers, such as the spruce, yellow and red pine varieties, either for length, evenness of grain, or freedom from knots, and it is to Canada that we in England are so deeply indebted for most of the timber used in our shipbuilding yards.

In Australia yachting has had, and in some places still has, a hard fight to assert itself against the exciting sport of horse-racing. The oldest yachting community is that stationed at Sydney, New South Wales, where the two leading clubs date back to the years 1863 and 1867, viz. the Royal Sydney Yacht Squadron, and the Prince Alfred Yacht Club. Yacht-racing, however, was carried on long before those years, and perhaps owing to the fine piece of water, some twelve square miles in area, enclosed within Port Jackson Heads, which lends itself to aquatic pursuits, yachting here has taken greater hold of the inhabitants than at any other place in the Southern Ocean. No finer boat sailers exist anywhere than at Sydney. There are a goodly number of yachts connected with the Port, and no money or care has been spared to keep the Sydney fleet up to date. Both Messrs. G. L. Watson and W. Fife, jun., to say nothing of other well-known designers, have from time to time given a helping hand towards furthering this end. The classes, however, which give the most sport, and which can draw together 5,000 or more onlookers during a racing day, are those that include the open boats. These are altogether a speciality of Sydney.

Yachting Vol. 2 — Part 190

The limits of the three principal classes are--for the

Yachting Vol. 2 — Part 190

First Class.--24 ft. length, with not less than 7 ft. beam, and 3 ft. depth.

Yachting Vol. 2 — Part 190

Second Class.--19 ft. length, with not less than 6.5 ft. beam, and 30 in. depth.

Third Class.--17 ft. length, with not less than 5 ft. beam, and 20 in. depth.

These boats are all centreboarders. When in Australia the writer was shown the 'Victor' as the finest example at that time of the large class. She was 34 ft. long, had 8 ft. beam, and a depth of 3 ft. A description of her was given in 'Hunt's Yachting Magazine' some years ago. She was built of colonial cedar, and of 1/2-in. planking. Her frames were of bent elm, the sternpost and knees of tea-tree, while her keel was of tallow-wood. Her draught aft was 21 in., and forward 2 in., with the crew of sixteen men on board. She carried a racing centreboard of 1/4-inch plating, 9 ft. long, and 6 ft. deep, with a double drop, allowing the plate when lowered to hang with its length horizontal to the keel. For ordinary occasions the racing centreboard was unshipped, and a smaller one substituted in its place. No dead ballast is allowed in these boats, and two air-tight or cork cushions are carried under the thwarts, because no boat is permitted to start for a race unless she possesses sufficient buoyancy to keep afloat should she happen to turn turtle or capsize. The 'Victor' was fitted, like all the boats of her class, with stringers running fore and aft, about two feet from the gunwale, which allowed the crew to sit double-banked, the outside contingent on the weather gunwale, with their feet under the stringer, the inside on the stringer itself. When shifting from the starboard to the port tack, or _vice versâ_, both outside and inside men go over at the same time, the inside men becoming outside, and the outside of the previous tack becoming inside. The 'Mantura' and 'Craigielee' are also fine specimens of the 24-feet class. Photographs of these two boats under way are hung in the billiard-room of the Royal Clyde Yacht Club House.