The Oberon class was a ship class of 27 British-designed submarines operated by five nations. They were designed as a follow-on from the Porpoise class; physical dimensions were the same but stronger materials were used in hull construction and improved equipment was fitted.

The Oberons operated during the Cold War, with duties including surveillance, tracking of other ships and submarines, delivery and retrieval of special forces personnel and serving as targets for anti-submarine training. Submarines of the class were in service until 2000.

Oberon-class submarine

The Oberon class was arguably the best conventional submarine class of its time, with a reputation for remarkable quietness. The quietness of the Oberon vessels enabled them to operate into the late 20th century until replaced by newer classes such as the Collins and Victoria classes in Australia and Canada, respectively.

Oberon-class submarine

The submarines were built between 1957 and 1978 by four shipyards: Cammell Laird (4), Chatham Dockyard (6), Scotts Shipbuilding and Engineering Company (11) and Vickers-Armstrongs (6). Thirteen of the submarines were operated by the Royal Navy, six by the Royal Australian Navy, three by the Brazilian Navy, three by the Royal Canadian Navy/Canadian Forces Maritime Command (plus two ex-Royal Navy boats later acquired for non-commissioned roles), and two by the Chilean Navy.

Oberon-class submarine

Design and construction

The -long Oberon class was based on the preceding Porpoise class of submarines, which were in service from 1956 to 1988. Changes from the Porpoise design were primarily to improve the strength and stealth of the submarine. Instead of UXW steel, the hull was built from QT28 steel, which was easier to fabricate and stronger, allowing the submarine to dive deeper. Glass-reinforced plastic was used in construction of the casing.

Electronics, sonar, and radar systems were also upgraded to the latest standard. The submarines were equipped with a type 1002 surface search and navigation radar, a type 187 active-passive attack sonar, and a type 2007 long-range passive sonar. The Oberons were constructed at a variety of shipyards in the United Kingdom: the six Australian and two Chilean submarines by Scotts Shipbuilding and Engineering Company (the latter were built after the Scott Lithgow merger); the three Brazilian submarines by Vickers-Armstrongs; and the three Canadian submarines at Chatham Dockyard. Construction of the British submarines was shared amongst four dockyards: the three mentioned above and Cammell Laird.

Armament

The Oberons were originally armed with eight torpedo tubes: six tubes in the bow, and two short tubes for antisubmarine defence in the stern. The submarine normally carried a payload of 20 torpedoes for the forward tubes; a mix of Mark 24 Tigerfish and Mark 8 torpedoes, while only the two preloaded Mark 20S torpedoes were carried for the stern tubes. Naval mines could be carried instead of torpedoes: the torpedo payload would be replaced with up to 50 Mark 5 Stonefish or Mark 6 Sea Urchin mines.

The forward torpedo tubes are constructed in two sections bolted together across the bulkhead at the fore end of the torpedo compartment. The long inner section is constructed of rolled steel fitted with welded flanges and support brackets. The outer section is constructed of a similar tube long but with a reinforced thick section behind the main bulkhead. The internal door hinges at one side with two locking mechanisms, a swing bolt opposite the hinge and a rotating locking ring attached to the tube which presses down on the ten projecting lugs around the door. The outer end of the tube is sealed with a domed bow cap. Bow shutters close across the bow caps so as to preserve the streamlined shape of the bow when the cap is closed.

The bow caps and shutters are mechanically linked to a hydraulically operated drive rod from within the torpedo compartment. The bow cap opens first behind the shutter, which then folds back against it forming a smooth exit tube. Interlocks prevent the doors at both ends being opened at the same time but the inner door is also provided with a test cock to check whether the tube is full of water before opening and remains held nearly closed by the swing bolt after the locking ring is released. The tube internal diameter is 22.5 in, wider than the torpedo, which is designed as a loose fit inside the tube. Torpedoes could be fired either electrically or with compressed air.

The aft torpedo tubes passed through the ballast tank at the rear of the submarine. A section projected into the boat through the bulkhead, forming overall a relatively short tube of , but of diameter.