“But, Sir, we live in a philanthropic age, and are bound to forgive our enemies and try to reform the worst criminals. I therefore propose a practical measure to win these book trimmers from their enormities; namely, that fifty at least of your readers, who care for book margins, should subscribe a guinea each for a challenge cup, to be competed for yearly, and held by that firm which, on producing copies of all books and pamphlets trimmed by it during the year, shall be adjudged to have disfigured them least. I ask you, Sir, if you will receive subscriptions for this challenge cup? If you will, I shall be glad to send you mine.
“P.S.—Any one who will cut out this letter, and get it pasted up in any binder’s or printer’s trimming room, will confer a favour on the writer.”
A very good trimming machine has been invented by Messrs. Richmond and Co., of Kirby Street, Hatton Garden. The bed rises and falls, with the books upon it, instead of the knife descending upon the work, as in the cutting machines; and the gauges are so arranged, that the foredge of one pile of books, and the tails of another, can be cut at one operation, and it is guaranteed by the makers that the knife will leave a clean and perfectly trimmed edge.
The book must now be glued up; that is, glue must be applied to the back to hold the sections together, and make the back firm during the rounding and backing. Knock the book perfectly true at its back and head, and put it into the lying press between two pieces of old mill-board; expose the back and let it project from the boards a little, the object being to hold the book firm and to keep the slips close to the sides, so that no glue shall get on them; then with glue, not too thick, but hot, glue the back, rubbing it in with the brush, and take the overplus off again with the brush. In some shops, a handful of shavings is used to rub the glue in, and to take the refuse away, but I consider this to be a bad plan, as a great quantity of glue is wasted.
The Germans rub the glue into the back with the back of a hammer, and take away the overplus with the brush; this is certainly better than using shavings. The back must not be allowed to get too dry before it is rounded, or it will have to be damped with a sponge, to give to the glue the elasticity required, but it should not be wet, this being worse than letting it get too dry. The book should be left for about an hour, or till it no longer feels tacky to the touch, but still retains its flexibility. A flexible bound book should first be rounded, a backing board being used to bring the sheets round instead of a hammer, then the back glued, and a piece of tape tied round the book to prevent its going back flat. |46|