Upright pianofortes frequently are hammered with felt weighing not more than 8 lbs. to the sheet, but this seems to be too light for really efficient results. 10 lbs. is quite light enough in most cases.

As has already been indicated, the foundation of the hammer is a wooden molding. Over this is glued, in the machine, a strip of “underfelt,” which is long enough to cover about five and a half or six octaves of hammers, counting from the bass end upwards. The main felting is then laid over this, the thickest end being at the lowest bass. By means of the machines, now so generally used, it is possible to glue the entire underfelt and also the topäfelt, in one piece. The moldings are then separated and the operation is complete. It is customary to insert a small piece of wire, doubled over in a loop, through each hammer, in order to ensure further strength to the fastening.

Theory and Practice of Piano Construction — Part 72

As may well be imagined, the details of manufacture, of the quality of the felting, and of the dimensions of the completed hammers, require much care in their execution. Long practice, study, and experience have combined to render the specialists, who devote themselves to the preparation of hammers and hammer-felt, most excellently fitted to place upon the market the very finest productions of this kind.

Theory and Practice of Piano Construction — Part 72

There have been attempts made at various times to provide a hammer head, and a method of felting it, that would obviate the somewhat rapid deterioration caused by the pounding of the glued and compressed felt against the stiff steel wire strings. The felt, which requires to be compressed before it is glued on to the wooden molding, rapidly becomes altogether too hard. Moreover, the fastening of the felt to the molding is by no means really permanent. It has been suggested that the felt might properly be contained within a wooden shell which would extend as far along the sides of the felt as the wooden molding now reaches within it. The compressed sheet of felt would be forced into this shell and fastened therein so that it would always be protected by an outer wooden covering. Thus, not only would the fastening of the felt to the wood be reduced more secure, but the pounding upon the strings would not so rapidly assure the undue hardening of the felt. For there would not be the hard wooden base between which the strings and the felt is continually subjected to compression. The idea is good and undoubtedly will yet be recognized.

Theory and Practice of Piano Construction — Part 72