Nothing as good as clear whey has been found for soaking rennets. Some think the acid an advantage in the working of the milk, and others go so far as to add, in cold weather, a quantity of sharp whey to the milk along with that in the prepared rennet. This, of course, hastens the development of acid throughout the mass. But we cannot say that we approve of doing anything to change the milk, and thus sour the curd before cooking. We prefer to have the milk as sweet as possible when set, and to keep the curd sweet until it is cooked. Then we would develop the acid in the whey. For this reason, if sour whey is to be added, we should add it after the curd is cooked, for the purpose of hastening the development of the lactic acid in the whey. This seems to us to be the most rational course, from what our experience has taught us. If fair experiment should demonstrate that we are in error as to when and where the development of the acid should take place, we shall be willing to yield the point.

The amount of prepared rennet that it is necessary to add to the milk, depends upon its strength, which can be determined only by experiment. Sufficient should be used to coagulate the milk in ten or fifteen minutes, and render it fit to cut in thirty or forty minutes. If the milk is "old," the same quantity of rennet will cause it to work sooner, as it should. Some would add less rennet. We would not. The milk needs to work faster, and the acid, although it coagulates the milk, will not supply the place of the rennet. The rennet ought to be strong enough to require not more than a quart to a thousand pounds of milk.

Hints on cheese-making — Part 33

Cheese-making was once carried on without cutting the curd; and even since the introduction of the factory system, there have been those who denounced the idea of using a cutting instrument. Breaking up the curd with the hands was considered the better method as incurring less waste, both of butter and cheese. Such ideas, though entertained but a few years ago, are obsolete. Cutting curds is now universal, certainly in America. The only questions are as to the time, manner and extent of cutting.

Hints on cheese-making — Part 33

When should the curd be cut? Practically, there is little difference of opinion on this question. Some may cut a little sooner or later than others, and even the same person may not always be precise as to the time of cutting. But all will agree that a curd should not be cut before it is firm enough to break square and smooth over the finger without whitening the whey; and they will also agree that it should be cut before it gets tough enough to drive along ahead of the knife. We would cut it as soon as it can be done without waste, while the curd is tender; and we would do all the cutting at once. There is no sense in running the knife through the curd one way, and then letting the curd stand and toughen before cross-cutting and completing the operation. If it is fit to partly cut, it is fit to wholly cut; and the sooner the cutting is done with, the better. Time for the separation of the whey can be given after the cutting is done, and before the heat is further raised.

Hints on cheese-making — Part 33