As morocco books only have morocco joints, I may as well explain at once how they are made. Morocco of the same colour is cut into strips the same length as the book, and about one inch and a half in breadth for 8vo.; a line is drawn or marked down each strip about half an inch from one edge, either with a pencil or folder, as a guide. The leather is now to be pared from the mark made to a thin edge on the half inch side, and the other side pared as thin as the leather turned in round the board, so that there will be two distinct thicknesses on each piece, the larger half going on the board to correspond with the leather round the three sides, and the smaller and thinly pared half going in the joint and edge on to the book. The end papers, only held in with a little paste, are to be lifted out from the book, and the leather well pasted is to be put on the board, so that the place where the division is made in the leather by paring will come exactly to the edge of the board; the thin part should then be well rubbed down in the joint, and the small thin feather edge allowed to go on the book.
Great care must be taken to rub the whole down well, that it may adhere properly; the grain need not be heeded. With regard to the overplus at the head and tail, there are two ways of disposing of it: first, by cutting both leathers slanting through at once, and making the two |99| meet; or, secondly, by cutting the cover away in a slant and doing the same to the joint, so that the two slant cuts cover each other exactly. This requires very nice paring, or it will be seen in the finishing. The book should be left till quite dry, which will take some five or six hours. The boards are then to be filled in by the same method as above described, and the end papers fastened in again properly.
_Cloth Joints._—If the cloth has been fastened in when the ends were made, after cleaning all unevenness from the joints, the boards are to be filled in as above, and the cloth joint stuck down with thin glue, and rubbed down well. The marble paper may now be put on the board by cutting it to a size a little larger than the filling in of the board, so that it may be well covered. When cloth joints are put in, the board paper is generally brought up almost close to the joint; but with morocco joints, the space left all round should be even.