The induced electro-motive force (which depends upon the rate at which the lines of force are cut) will be constant for the given speed at which the armature rotates. This action is the same as that described for the uni-direction current machine.
Figure 14 is the diagram of a “series”-wound dynamo. The field and armature are soft gray iron, and are wound in series--that is, one end of the magnet-winding is made fast to the brush B, the other to the brush B B, and the apparatus to be operated by the current is let in between B B and the magnet, as shown by the indicated electric arc-light in the illustration. The field-magnet coils, the armature, and the external conductors are in series with each other, forming a simple circuit. When the armature is driven at high speed the field-magnets become self-exciting, with the result that current is generated. Its simple course is through B B to commutators on the hub, thence through one winding on the iron armature A, to B, through field F, and back to B B again, operating in its course any pieces of equipment designed for electric impulse, such as motors, or lamps, trolley-cars, trains, or electric machinery.
The third type, shown in Fig. 15, is known as “shunt”-winding. The field-magnet coils and the external resistance are in parallel, or shunt with each other, instead of in series. The brushes are connected with the external circuit, and also with the ends of the field-magnet coils. This is clearly shown in the drawing. The ends of the field-coils are connected with brushes B and B B, and the external circuit wires are connected also with the same brushes, and pass down to such an apparatus as a plating bath, in which the current runs through the electrode, the electrolyte, and the cathode, most of the current generated passing through the external circuit. The field-coils are of fine wire, and when the armature is rotated there will always be a current through the field-magnets, whether the external circuit is complete or not. If a break occurs in the external circuit, a more powerful current will consequently pass through the field-magnets.
In Fig. 16 a “compound”-wound dynamo is shown. It is a combination of the series and the shunt machine. The field-magnet coils are composed of two sizes of wire. There are comparatively four turns of stout wire and many turns of fine wire, the ends of both being connected, as shown in the drawing. The stout wire leads out to lamps which are arranged in series, as shown at the foot of the drawing. The current developed by this dynamo is one of “constant potential,” and is used almost exclusively for incandescent lamps, the “constant” current from the series-wound machine being used for arc-lamps, power, and other commercial purposes.