The following description of a water engine of world-wide adaptation will, if attentively studied, show the working of an approved type of this machine:
Ramsbottom’s hydraulic engine (Figs. 129 and 130), is oscillating, and employs two cylinders _b_, _l_, operating one crank-shaft, _a_, by means of two cranks at right angles to each other. In one of the accompanying figures the channels of induction are marked _j_ and are cast on the cylinders; the dotted circle _c_ shows the position of the supply and discharge pipes; in the other figure these pipes are indicated by arrows. The two views are vertical cross-sections at right angles to each other, one being through the axis of the cylinders and the other through the middle post in which the inner trunnions of the cylinders are journaled. The apertures of induction are seen at _h_ and those of eduction at _i_, and have the form of truncated circular sectors, whose center is the center of motion.

The induction and eduction spaces are divided by a sectoral partition; the apertures of admission and discharge on the sides of the cylinders are of similar construction. The surfaces of contact between the cylinders _b_, _l_ and the support _d_ are planed and polished and are made water-tight by the adjusting screws _m_ _m_ of the pivots. When the piston _p_ is at the end of its course in either direction the cylinder and crank are vertical, and the valves all momentarily closed, the openings by which the channels _j_ _j_ communicate with the discharge and supply pipes presenting themselves exactly opposite the solid sectors which separate _h_ from _i_.

In the next moment the flow of water will recommence, the cylinder discharging itself from the full side of the piston, and filling anew from the opposite side. Air chambers and relief-valves are used as a provision against counter-pressure and hydraulic shocks.

The Brotherhood three-cylinder reciprocating engine is an appliance for producing rotary motion by water-pressure.
The working parts of the Brotherhood three-cylinder hydraulic engine consist only of the three pistons and connecting rods, one crank and one rotating balanced valve and spindle which fits into the driver and is turned direct from the crank-pin; there are no glands, stuffing boxes, or oscillating joints.





