Figs. 4 and 5 represent in detail the manner in which electric connection is made in two cases requiring the intervention of the stop motion. In Fig. 4 the upper part of a receiving can is shown. When the can is full the cotton lifts the tube wheel, J, until it makes an electrical connection, and the stop motion is brought into instant action. In Fig. 5, the traction upon the yarn holds the hook borne by the spring, F, away from G, and the electric circuit is interrupted. A breakage of the yarn allows this spring to act; contact is made, and the stop motion operates as before.

This simple and efficient device is exhibited by Howard & Bullough & Riley, of Boston.

Scientific American Supplement, No. 362, December 9, 1882 — Part 10

Fig. 6 shows the essential features of a positive motion loom, intended for weaving narrow fabrics, exhibited by Knowles, of Worcester, Mass. The engraving shows so clearly how, by a right and left movement of the rack, the shuttle is thrown by the action of the intermediate cogwheels, that further description is unnecessary.

Scientific American Supplement, No. 362, December 9, 1882 — Part 10

At the recent semi-annual meeting of the New England Cotton Manufacturers' Association, held at the Institute of Technology, Boston, the following paper on the Harris system of revolving ring spinning was read by Col. Webber for the author:

Scientific American Supplement, No. 362, December 9, 1882 — Part 10

It is well known that one of the most serious difficulties in ring spinning is the variable pull upon the traveler, caused by the difference in diameter of the full and empty bobbins, and this is especially noticeable in spinning weft, or filling, when the diameter of the quill at the tip is not over 3-16 of an inch, while that of the base of the cone, or full bobbin, is from an inch to an inch and one-eighth. This variation in diameter causes the line of draught upon the traveler, which, with the full bobbin, forms nearly a tangent to the interior circle of the ring, to be nearly radial to it with an empty one, and this increased drag upon the traveler not only causes frequent breakage in spinning, but also stretches the yarn, so that it is perceptibly finer when it is spun on the nose of the bobbin than when it is spun on the bottom of the cone.

Endeavors have been made to compensate for this difficulty by making a less draught at that period of the operation; but we believe the principle of curing one error by adding another to be wrong, and aim by our improvement to avoid the cause of the trouble, which we do by giving a revolving motion to the ring itself in the same direction as that of the traveler, at a variable speed, so as to aid its slip, and reduce its friction on the ring. This we accomplish by means of a shaft with whorls on it, located directly over the drum for driving the spindle, from which bands drive each ring separately; and attached by cross-girts to the ring-rail, and moving up and down with it.