All this appears complicated, but it is very necessary to get a good surface for printing. The action of the gum does not appear to be clearly understood, the nitric acid obviously will etch the stone, so that the gum will easily penetrate. It is sometimes supposed that the arabic acid of the gum enters into a chemical composition with the calcium carbonate, making a film which is the real ink-resisting surface. This film has not a long life, so that in printing it is necessary to renew it periodically by the application of gum solution.
If possible, the stone should be allowed to rest for a day or two after proving, in order that the ink may sink well in.
Before printing, the gum is washed off and the stone allowed to remain in the press-room until its temperature is the same as its surroundings. The stone is then thoroughly and evenly damped all over, placed in the press, and rolled up with lithographic ink; the paper is then laid on, and the whole passed through the lithographic press. After the first few pulls it will be seen whether all is well. The essentials of a good impression are these: the lines must be black and not grey, provided black ink is used; the lines must not be wider or blacker ("smutty") than those on the stone, nor must they be ragged or broken ("rotten").
In printing, the stone must be damped and inked before each impression is taken, and occasionally re-gumming is required. Good printing requires a considerable amount of ability, especially in the case of crayon drawings.
The paper used is a very important matter, the selection of which can be safely left to the lithographer, provided he be a good one, unless the author possesses the necessary technical knowledge. If a smooth paper is required, and the paper is not to be damped before printing, India paper is best and plate paper next best. All coarse or grained papers must be damped before printing.
As has already been remarked, lithography is a good process for scientific work; but, unfortunately, considering the number of lithographic plates published, really first-class examples are rare. This is largely due to the original draughtsman; it is unreasonable to expect a lithographer, in all probability ignorant of the subject of the plate, to turn out first-class reproductions of drawings which are obviously bad. On the other hand, lithographers vary greatly in their capabilities, and indifferent plates may be entirely due to their ability not being first rate.