It will now be seen why we did not at once bore the holes, or rather mark their places, on the rack-board. Plainly, we must make these twelve grooves first, and cover them in. Then, replacing the rack-board as before, carefully mark on the latter the exact place of each bass pipe, as it will stand on any part of its secondary groove. Afterwards, with a bradawl or other sharp-pointed borer, prick quite through the rack-board at every one of the points which you have marked throughout its whole extent. At these points there will hereafter be circular holes of various sizes for the reception of the pipe-feet, but in the upper boards, sliders, and tables there will be smaller holes, adapted for conveying its stream of air to each pipe. Before removing the rack-board, decide upon the places where the rack-pins, or pillars which will hold the rack-board up above the sound-board, are to be. Have plenty of these, say six or eight if you have a single rack-board, or five to each if you have two, in order to insure a firm plantation of the pipes, and bore holes for them with a centre-bit, say 5/8 diameter, through the rack-board and to the depth of 1 inch in the upper boards.

The rack-board now being put aside for the present, all the holes may be bored through the upper boards, sliders, and table with bits of various sizes. From what has been said above it will be seen that it is not the sizes of these holes, but of the apertures in the pipe-feet, which regulate the volumes of wind supplied to the pipes; but you will, of course, use bits proportioned to the pipes you have in view. The upper, or treble, holes must not let the little pipes slip into them, nor must the larger holes throttle or check the flow of the wind. In the bass the holes may be as large as the grooves will allow; and if these are narrow, or if there is secondary grooving or conducting, it will be well to cut the round hole at its interior aperture with a sharp chisel into a square or rectangular opening; or to bore two round holes and connect them by taking out the intervening wood. Afterwards, with iron rods of various sizes, heated to redness, scorch all the holes through the three thicknesses of wood, leaving a clear and smooth charred passage for the wind.

Practical Organ Building — Part 26