Photosynthetically active radiation (PAR) designates the spectral range (wave band) of solar radiation from 400 to 700 nanometers that photosynthetic organisms are able to use in the process of photosynthesis. This spectral region corresponds more or less with the range of light visible to the human eye. Photons at shorter wavelengths tend to be so energetic that they can be damaging to cells and tissues, but are mostly filtered out by the ozone layer in the stratosphere. Photons at longer wavelengths do not carry enough energy to allow photosynthesis to take place.

Other living organisms, such as cyanobacteria, purple bacteria, and heliobacteria, can exploit solar light in slightly extended spectral regions, such as the near-infrared. These bacteria live in environments such as the bottom of stagnant ponds, sediment and ocean depths. Because of their pigments, they form colorful mats of green, red and purple.

Photosynthetically active radiation

Chlorophyll, the most abundant plant pigment, is most efficient in capturing red and blue light. Accessory pigments such as carotenes and xanthophylls harvest some green light and pass it on to the photosynthetic process, but enough of the green wavelengths are reflected to give leaves their characteristic color. An exception to the predominance of chlorophyll is autumn, when chlorophyll is degraded (because it contains N and Mg) but the accessory pigments are not (because they only contain C, H and O) and remain in the leaf producing red, yellow and orange leaves.

Photosynthetically active radiation

In land plants, leaves absorb mostly red and blue light in the first layer of photosynthetic cells because of chlorophyll absorbance. Green light, however, penetrates deeper into the leaf interior and can drive photosynthesis more efficiently than red light. Because green and yellow wavelengths can transmit through chlorophyll and the entire leaf itself, they play a crucial role in growth beneath the plant canopy.

Photosynthetically active radiation

PAR measurement is used in agriculture, forestry and oceanography. One of the requirements for productive farmland is adequate PAR, so PAR is used to evaluate agricultural investment potential. PAR sensors stationed at various levels of the forest canopy measure the pattern of PAR availability and utilization. Photosynthetic rate and related parameters can be measured non-destructively using a photosynthesis system, and these instruments measure PAR and sometimes control PAR at set intensities. PAR measurements are also used to calculate the euphotic depth in the ocean.

In these contexts, the reason PAR is preferred over other lighting metrics such as luminous flux and illuminance is that these measures are based on human perception of brightness, which is strongly green biased and does not accurately describe the quantity of light usable for photosynthesis.

Units

When measuring the irradiance of PAR, values are expressed using units of energy (W/m2), which is relevant in energy-balance considerations for photosynthetic organisms.

However, photosynthesis is a quantum process and the chemical reactions of photosynthesis are more dependent on the number of photons than the energy contained in the photons. Therefore, plant biologists often quantify PAR using the number of photons in the 400-700 nm range received by a surface for a specified amount of time, or the Photosynthetic Photon Flux Density (PPFD). Values of PPFD are normally expressed using units of mol⋅m−2⋅s−1. In relation to plant growth and morphology, it is better to characterise the light availability for plants by means of the Daily Light Integral (DLI), which is the daily flux of photons per ground area, and includes both diurnal variation as well as variation in day length.

PPFD used to sometimes be expressed using einstein units, i.e., μE⋅m−2⋅s−1, although this usage is nonstandard and is no longer used.

Light fixture efficiency

Yield photon flux

There are two common measures of photosynthetically active radiation: photosynthetic photon flux (PPF) and yield photon flux (YPF). PPF values all photons from 400 to 700 nm equally, while YPF weights photons in the range from 360 to 760 nm based on a plant's photosynthetic response.