When the deviations from purity are as slight as in the cases that we have been considering, it is by no means easy to determine, at all times, whether the note that is being tuned is sharp or flat of its tonic. For the beats occur similarly in either case and few ears can determine the relative sharping or flatting without some extraneous aid. Fortunately, however, we have a variety of tests open to us, which for completeness and accuracy leave nothing to be desired.

To take a concrete example, during the “laying of the bearings” we first tune the F below middle C, then the G below middle C, and then the D above G. When we reach this last note, we find that a sixth has been obtained; namely, F--D. Now if the notes already tuned have been tempered, so as to be too _flat_, the resultant sixth will beat too _slowly_, and, conversely, if the tuned notes be too _sharp_ the sixth will beat too _fast_.

Theory and Practice of Piano Construction — Part 99

This test may be amplified when we proceed to the next interval, D--A. When this latter note has been tuned, we have the triad F--A--C. F--A is a major third, and by referring to previous calculation we see that as such it must, when properly tempered, be considerably sharp. By noting the beats of the major third and likewise the beats of the sixth we may correct the tuning of all the sounds with which we have hitherto dealt. The same process is, of course, carried on throughout the whole process of “laying the bearings.” The major thirds and sixths are tested continually as the tuning proceeds, and thus is provided a sure guide to the correctness of the fourths and fifths.

Theory and Practice of Piano Construction — Part 99

The correct beat-rates for the major thirds may be stated as about eight per second, while that for the major sixths is approximately eleven in the same period. Of course, as already stated, these rates per second cannot be measured with accuracy, but with practice one soon discovers by ear the proper roughness in each case, and is thus enabled to estimate the beat rates without much trouble. Every opportunity of examining the work of good tuners should be taken by the observer, who should note carefully the beat-rates which they assign to each kind of interval. In this way he will provide himself with practical examples of tempering of intervals which will be of great value to him.

Theory and Practice of Piano Construction — Part 99