A musical composition which is to be performed on the pianoforte by means of one of these “players,” as they are called colloquially, is first reduced to a series of perforations on a long sheet, the perforations being of uniform width, but varying in length according to the duration of the musical tone for which each stands. The sheet is then wound upon a spool and is connected with motor mechanism which is adapted to draw it across a “tracker-board” pierced with holes, each of which corresponds to some hole in the sheet. The latter, when so drawn across the plane of the “tracker-board,” is wound up on another spool, and the motor mechanism of the player is so arranged that the sheet can be re-wound on to its own spool when the whole composition has been played, so that it may be withdrawn from the “player,” and another substituted in its place. The actual process of operation is as follows: The “player” is provided with foot pedals, which operate exhaust bellows, and thus maintain a reservoir bellows in a state of exhaust, on the same principle as in the reed organ. As long as the exhaust bellows are operated, and the reservoir is kept in a state of vacuum, it is possible to maintain an “exhaust chamber” within the “player” also in a state of vacuum. This exhaust chamber communicates with a “diaphragm chamber,” in connection with the “tracker-board” hole, and with an “inflation and deflation channel” in connection with the striking pneumatic or bellows which depresses the pianoforte key. The connection with the “diaphragm chamber” is by means of a very small hole pierced in a leather diaphragm which is stretched between the “exhaust chamber” and the “diaphragm chamber,” so that the latter will be in a state of partial vacuum. Resting on the leather diaphragm is a button, attached to an upright spindle which stretches through an orifice into the inflation and deflation chamber, and there operates a poppett valve which, in one position of the spindle, will close the chamber against the exhaust chest, while opening itself and therefore also the pneumatic to the outer air, and in another position will reverse the process, opening the chamber to the power of the vacuum in the exhaust and simultaneously closing itself and therefore the pneumatic to the vacuum, which will cause the latter to collapse, and thus bring down the key. Now, when a hole in the perforated sheet comes opposite a hole in the “tracker-board,” an atmospheric communication is opened with the “diaphragm chamber,” and air will immediately rush down into the “diaphragm chamber” and at once destroy the partial vacuum which existed there. As a consequence of this, the leather diaphragm will immediately rise to its fullest extent, influenced by the vacuum in the chamber above it, and will therefore push up the poppett valve. This action will open communication between the exhaust and inflation and deflation chambers and will expose the latter to the vacuum, while shutting off the outer air which has kept the pneumatic inflated. Thus the pneumatic will collapse, and the piano key will be held down until the closing of the “tracker-board” hole once more restores the partial vacuum in the “diaphragm chamber,” thus permitting the poppett valve to sink, and reopening the connection between the pneumatic and the outer air, which re-inflates it and releases the key.