Armour-piercing, capped, ballistic capped (APCBC) is a type of configuration for armour-piercing ammunition introduced in the 1930s to improve the armour-piercing capabilities of both naval and anti-tank guns. The configuration consists of an armour-piercing shell fitted with a stubby armour-piercing cap (AP cap) for improved penetration properties against surface hardened armour, especially at high impact angles, and an aerodynamic ballistic cap on top of the AP cap to correct for the poorer aerodynamics, especially higher drag, otherwise created by the stubby AP cap. These features allow APCBC shells to retain higher velocities and to deliver more energy to the target on impact, especially at long range when compared to uncapped shells.

The configuration is used on both inert and explosive armour-piercing shell types: Armour-piercing (AP), capped, ballistic capped (APCBC) Semi-armour-piercing (SAP), capped, ballistic capped (SAPCBC) Armour-piercing, high-explosive (APHE), capped, ballistic capped (APHECBC) Semi-armour-piercing, high-explosive (SAPHE), capped, ballistic capped (SAPHECBC)

Armour-piercing, capped, ballistic capped shell

The APCBC configuration is an evolution of the earlier APC configuration (armour-piercing, capped), itself an evolution of the simple AP configuration (armour-piercing, uncapped). The APCBC configuration is however expensive and thus a large amount of both historical and modern armour-piercing ammunition uses only one of the two caps: APC (armour-piercing, capped) and APBC (armour-piercing, ballistic capped).

Armour-piercing, capped, ballistic capped shell

Design

Ballistic cap

By 1910 it was well-established that the aerodynamically optimal form of a solid projectile does not lend itself to best-attainable armour penetration, and remedies were devised.

Armour-piercing, capped, ballistic capped shell

A ballistic cap (BC) is a hollow thin-walled aerodynamically shaped metal cone mounted on the top of a projectile to cover it with a more aerodynamically efficient shape. This reduces drag in flight, so higher velocity and hence range is obtained giving better penetration over longer distances. On impact, the ballistic cap will break off or collapse without affecting the impact performance of the armour-piercing cap and penetrator.

Ballistic caps are used on a great variety of projectiles other than APCBC shells and exist to allow the projectile or cap underneath to have a less aerodynamic shape more suitable for the effect of the munition. They are most often fitted by pressing the edges of the cone into a groove around the edge of the projectile or AP cap.

Armour-piercing cap

The primary job of an armour-piercing cap (AP cap, most often shortened to cap) is to protect the tip of the penetrator (the shell) on impact, which could otherwise shatter and not penetrate. It consist of a metal cap, often solid in structure, which, is mounted on top of the projectile lying against the tip. Depending on the purpose of the cap, different designs exist. Among other things, the cap can be made of soft metal (soft cap), or hard metal (hard cap).