Many electric cooking-utensils are made for the household, such as coffee-percolators, egg-boilers, ovens, disk stoves, etc. Each one is equipped with a resistance-coil like that in the electric flat-iron just described, so that it contains its own source of heat, which is under perfect control by means of a switch. An “electric kitchen” consists of a number of these utensils, wired to a convenient table or stand, as shown in Fig. 7.
We have seen that the modern way to generate electricity is from mechanical energy applied through a dynamo, and that the “electric power” thus generated may be transmitted over wires to a distance and there transformed into other forms of energy, such as light, heat, and chemical energy, or reproduced again as mechanical energy. The last mentioned of these transformations is the most important of them all, because it is the one that means the most for the advancement of civilization. Before the invention of the dynamo and the discovery that it was reversible, mechanical power could be employed only in the place where it was generated, so that its use was restricted; whereas nowadays the field of power is broadened and its cost reduced by electrical transmission and distribution.
In the chapter on Dynamos and Motors we learned how to make and use those machines. Let us review, very briefly, just what happens in the double transformation--of mechanical energy into electricity and then back again at the end of a line of wires--that we call electric-power transmission. In the dynamo, the power of the water-wheel, or whatever other prime mover is used, is exerted in generating electricity by forcing the electric conductors of the machine through a magnetic field. The electricity is led away to a distance--a hundred miles, perhaps--by wires and allowed to enter another machine similar to the dynamo, but operating as a motor. Here the first process is reversed: the electricity passing through the conductors of the motor reacts upon its magnetic field, causing the machine to revolve and thus generating mechanical power again. The line-wires carry the power just as positively as though a long shaft ran from the prime mover to the receiving end of the line, and much more economically. The action that goes on is similar to the operation of the telephone--which is indeed a special case of electric-power transmission--as already explained in a former chapter: the sound of the voice being transformed, at the telephone-transmitter, into electrical energy in the form of alternating currents, then carried as such over the line and finally reproduced as sound again at the receiver.