IEEE 802.1aq is an amendment to the IEEE 802.1Q networking standard which adds support for Shortest Path Bridging (SPB). This technology is intended to simplify the creation and configuration of Ethernet networks while enabling multipath routing.

SPB is designed to replace the older spanning tree protocols: IEEE 802.1D STP, IEEE 802.1w RSTP, and IEEE 802.1s MSTP. These block any redundant paths that can result in a switching loop, whereas SPB allows all paths to be active with multiple equal-cost paths, provides much larger topologies, supports faster convergence times, and improves the efficiency by allowing traffic to load share across all paths of a mesh network. It is designed to preserve the plug-and-play nature that established Ethernet as the de facto protocol at layer 2.

IEEE 802.1aq

The technology provides VLANs on native Ethernet infrastructures using a link-state protocol to advertise both topology and VLAN membership. Packets are encapsulated at the edge either in MAC-in-MAC per IEEE 802.1ah or tagged per IEEE 802.1Q or IEEE 802.1ad and transported only to other members of VLAN. Unicast, multicast, and broadcast are supported and all routing is on symmetric shortest paths.

IEEE 802.1aq

The control plane is based on the Intermediate System to Intermediate System (IS-IS) routing protocol, leveraging a small number of extensions defined in .

IEEE 802.1aq

History

On 4 March 2006 the working group posted 802.1aq draft 0.1. In March 2012 the IEEE approved the 802.1aq standard.

In May 2013, the first public multi-vendor interoperability was demonstrated as SPB served as the backbone for Interop 2013 in Las Vegas. In 2013 and 2014 SPB was used to build the InteropNet backbone with only one-tenth the resources of prior years. During Interop 2014 SPB was used as the backbone protocol which can enable software-defined networking (SDN) functionalities.

The 2014 Winter Olympics were the first "fabric-enabled" Games using SPB "IEEE 802.1aq" technology. During the games this fabric network could handle up to 54 Tbit/s of traffic.

Associated protocols

IEEE 802.1Q-2014 - Bridges and Bridged Networks - This standard incorporates Shortest Path Bridging (IEEE 802.1aq) with the following: IEEE Std 802.1Q-2011, IEEE Std 802.1Qbe-2011, IEEE Std 802.1Qbc-2011, IEEE Std 802.1Qbb-2011, IEEE Std 802.1Qaz-2011, IEEE Std 802.1Qbf-2011, IEEE Std 802.1Qbg-2012, IEEE Std 802.1Q-2011/Cor 2–2012, and IEEE Std 802.1Qbp-2014, and much functionality previously specified in 802.1D. IEEE 802.1ag - Connectivity Fault Management (CFM) IEEE 802.1Qbp - Equal Cost Multiple Paths in Shortest Path Bridging IEEE P802.1Qcj - Automatic Attachment to Provider Backbone Bridging (PBB) services RFC 6329 - IS-IS Extensions Supporting IEEE 802.1aq Shortest Path Bridging

RFC 6329

The Intermediate System to Intermediate System (IS-IS) protocol, as defined in the IETF proposed standard , is used as the control plane for SPB. SPB requires no state machine or other substantive changes to IS-IS, and simply requires a new Network Layer Protocol Identifier (NLPID) and set of TLVs.

SPB allows for shortest-path forwarding in a mesh-connected Ethernet network utilizing multiple equal-cost paths. This permits SPB to support large Layer 2 topologies, with faster convergence, and improved use of the mesh topology when compared to networks configured with Spanning Tree Protocol. SPB augments IS-IS with a small number of TLVs and sub-TLVs, and supports two Ethernet encapsulating data paths, 802.1ad Provider Bridges (PB) and 802.1ah Provider Backbone Bridges (PBB).

SPB is designed to run in parallel with other network layer protocols such as IPv4 and IPv6. Standards mandate that the failure of two nodes to establish an SPB adjacency will not have a collateral impact, such as the rejection of an adjacency for other network layer protocols (e.g. OSPF).

Protocol extensions

The IS-IS extensions defined in RFC 6329 that deliver standardized support for 802.1aq SPB are: IS-IS Hello (IIH) Protocol Extensions Node Information Extensions Adjacency Information Extensions Service Information Extensions