Nevertheless, although the parts of the water thus loosely slip and slide upon one another, yet they hold together to a certain extent. If the surface of the water is just touched with the finger, a little of it will adhere; and if the finger is then slowly and carefully raised, the adjacent water will be raised up into a slender column which acquires a noticeable length before it breaks. So, in the early morning, after heavy dew, you may see the water upon cabbage-leaves and blades of grass in spherical drops, the parts of which similarly hold together.
Material substances, the parts of which are so movable that they fit themselves exactly to the sides of any vessel which contains them, and which flow when they are not supported, are called =fluids=, and fluids the parts of which do not fly off from one another, but hold together as those of water do, are called =liquids=.
It has been seen that water, like every other material substance, resists the intrusion of other matter into the place which it occupies. But many things, though they resist, can be easily squeezed or =compressed= into a smaller volume. This, however, is not the case with water, which like other liquids, is almost =incompressible=; that is to say, an immense pressure is needful to cause its volume to diminish to any appreciable extent. It may seem strange that anything so apparently yielding as water should yet be almost as difficult to squeeze as so much iron; but the apparent yieldingness of water is due to the ease with which it changes its shape; and, if water is prevented from changing its shape, it is very difficult to drive its parts closer together. It has been ascertained that if water is confined in a closed space, a pressure amounting to fifteen pounds on the square inch diminishes its volume by only 1/20000th part. Take a common syringe, and having seen that the plug or =piston= fits the =cylinder= of the syringe well, put the nozzle into water and draw the piston up. Then turn the nozzle upward and push upon the piston till a little of the water squirts out, so as to make sure that the cylinder contains nothing but water. Now put your finger on the opening of the nozzle firmly, so as to stop any water from passing out, and then try to push the piston down. You will find that you cannot make it stir without great force; and, if the piston moves appreciably, it will be because some of the water has escaped by the sides of the piston. In fact, if the piston presented a square inch of surface, and fitted accurately, and the column of water in the cylinder were one inch long, it must be pressed down by a weight of 30,000 pounds (about thirteen tons) to make it move one-tenth of an inch.