Now that is finished firm and strong, and you can
in a few moments. Lay the floor (Fig. 205) down flat on a table; bend up the two diagonal sides O and O, and slide the slit P in the side wall (Fig. 206) down into the slit P of the floor (Fig. 205), bringing the wall (Fig. 206) in front of the upturned floor-piece O (Fig. 205). In the same way fasten the other side wall on the floor. Slip the two slits Q and Q of the back wall (Fig. 207) down across the top slits (Q, Fig. 206) of the side walls. While bringing the back wall (Fig. 207) down to the floor, slide its outside strips S and S over and outside of the upturned pieces of the floor, S and S (Fig. 205), to hold them in place.
[Illustration: Fig. 215.--Pattern for andiron.]
As soon as the Indian's wigwam was up, he had a brisk fire to cook by, for after shelter came food. The white man did likewise after his house was built. Though he had andirons to help with his fire, even then to
in the immense fireplace required some skill. Cut two andirons of cardboard (Fig. 215), bend at dotted lines, paint black, and the andirons will stand alone and look like real ones (Fig. 216).
Cut from red, orange, yellow, and black tissue-paper flames like Fig. 217; bend at dotted line and paste the mingled flames one at a time and turned in varying directions on a piece of cardboard made to fit the bottom of the fireplace. Adjust the little black andirons to the fire and glue them in place; select a large log for the "back-log," and a more slender one to lay across the front of the andirons. Place smaller wood in between with the flames, and scatter a few bits of black paper on the hearth underneath to appear like fallen charred wood. When finished the fire should look as if it were actually sparkling, roaring, and blazing (Fig. 218).
[Illustration: Fig. 218.--The flames leap up the chimney.]
[Illustration: Fig. 219.--Cut the shell in half.]
Your fire is ready, so you must hurry and get the
to hang over the flames. Break an egg in halves as indicated by dotted lines in Fig. 219; even off the edge of the larger half shell with a pair of scissors, paste a strip of tissue-paper over the edge and glue on a stiff paper handle (Fig. 220). Cut three pieces of heavy, stiff paper like Fig. 221, bend at dotted line and pinch the two lower corners on part T together to form the pot legs (Fig. 222). Turn the egg-shell upside down and fasten the legs on by gluing the flap U (Fig. 221) on the bottom of the shell; the legs should enable the pot to stand upright. Turn the egg-shell into iron by painting the handle and outside of the pot jet black (Fig. 223). Swing the crane forward, hang on the pot, pretend you have something to cook in it, then move the crane back over the fire.