The Bermuda sloop is a historical type of fore-and-aft rigged single-masted sailing vessel developed on the islands of Bermuda in the 17th century. Such vessels originally had gaff rigs with quadrilateral sails, but evolved to use the Bermuda rig with triangular sails. Although the Bermuda sloop is often described as a development of the narrower-beamed Jamaica sloop, which dates from the 1670s, the high, raked masts and triangular sails of the Bermuda rig are rooted in a tradition of Bermudian boat design dating from the earliest decades of the 17th century. It is distinguished from other vessels with the triangular Bermuda rig, which may have multiple masts or may not have evolved in hull form from the traditional designs.
History
Jamaica was the locus of building fast single-masted vessels that became the model for small cruisers of the Royal Navy. Building of this type of vessel had become more active in Bermuda by the start of 18th century. Bermuda shipbuilders constructed sloops and other vessels, starting in the mid 17th century. Their sloops were gaff-rigged. The first triangular mainsails, characteristic of the Bermuda rig, were introduced on coastal vessels by the 1620s, but most sea-going vessels were gaff-rigged until the 1820s. The sloops were constructed in a range of sizes up to . The most prevalent size for such sloops was in the range of on deck with a long bowsprit.
Jamaican sloops had beams that were narrower than ocean-going Bermuda sloops, and could attain a speed of around 12 knots. They carried gaff rig, whereas in modern usage, a Bermuda sloop excludes any gaff rig. Jamaican sloops were built usually out of cedar trees, for much the same reasons that Bermudian shipwrights favoured Bermuda cedar: these were very resistant to rot, grew very fast and tall, and had a taste displeasing to marine borers. Cedar was favoured over oak as the latter would rot in about 10 years, while cedar would last for nigh on 30 years and was considerably lighter than oak. When the ships needed to be de-fouled from seaweed and barnacles, pirates needed a safe haven on which to careen the ship. Sloops were well suited for this because they were able to sail in shallow areas where larger ships would either run aground or be unable to sail through at all. These shallow waters also provided protection from ships of the British Royal Navy, which tended to be larger and required deep water to sail safely.
Later in the 19th century, the design of Bermudian vessels had largely dispensed with square topsails and gaff rig, replacing them with triangular main sails and jibs. The Bermuda rig had traditionally been used on vessels with two or more masts, with the gaff rig favoured for single-masted vessels. The reason for this was the increased height necessary for a single mast, which led to too much canvas. The solid wooden masts at that height were also too heavy, and not sufficiently strong. Single-masted sloops quickly became the norm in Bermudian racing, with the introduction of hollow masts and other refinements.
The colony's lightweight Bermuda cedar vessels were widely prized for their agility and speed, especially upwind. The high, raked masts and long bowsprits and booms favoured in Bermuda allowed its vessels of all sizes to carry vast areas of sail when running down-wind with spinnakers and multiple jibs, allowing great speeds to be reached. Bermudian work boats, mostly small sloops, were ubiquitous on the archipelago's waters in the 19th century, moving freight, people, and everything else about. The rig was eventually adopted almost universally on small sailing craft in the 20th Century, although as seen on most modern vessels it is very much less extreme than on traditional Bermudian designs, with lower, vertical masts, shorter booms, omitted bowsprits, and much less area of canvas.