U. S. standard thread 159 method of cutting 146 Universal chuck for lathe 36
V-thread and tool for cutting 159 Vertical boring mill, Bullard turret lathe type 264 convex turning attachment 259 general description 242 holding and setting work 247 taper turning in 261 taper turning with horizontal and vertical feeds 262 tools for boring and reaming 251 turning flywheel in 255 turning tools for 253 Vertical turret lathe, Bullard, examples of work 268
Whitworth standard thread and tool for cutting 158, 159 Wire system for measuring threads 163 Worm thread and tool for cutting 159, 160
Transcriber's notes on changes made to text: Left as in original: use of degree, deg. and °; use of minute, min. and '.
Standardised to the most commonly used in the book: backgear to back-gear; camshaft to cam-shaft; crankpin to crank-pin; face-plate to faceplate; out-board to outboard; over-hang to overhang; setscrew to set-screw; steady-rest to steadyrest; subdivision(s) to sub-division(s); tail-stock to tailstock; thumbscrew to thumb-screw; tool-post to toolpost; tool-slide to toolslide; hand-wheel to handwheel; U.S. to U. S.
Page 64 had a blotched (illegible) word, this has been replaced by (large and rigid) work.
Table of Contents: largely re-compiled to create one-to-one links with named paragraphs and sections in text.
End of the Project Gutenberg EBook of Turning and Boring, by Franklin D. Jones