=a.= The 3‐cell, 15‐plate, 6‐volt, 22‐ampere‐hour battery is located in battery box back of frame seat post tube, and is accessible for inspection and or service after removing box cover. Normally charged battery has specific gravity reading of 1.275. Normally discharged battery has specific gravity of 1.150.
(1) Raise saddle and bar assembly after releasing and removing swivel pin.
(2) Loosen wing thumb nuts on box top hold‐down studs sufficiently to disengage bracket slots, then lift off box cover.
(3) Remove the three filler plugs. Check and or adjust electrolyte level. See that electrolyte level is 5/16 inch above plates. If necessary, bring electrolyte to that level, using clean, drinkable water.
(4) Clean top of battery before installing box cover.
(5) Clean terminals or posts, if corroded. Make sure that the felt washers are on posts and are saturated with engine oil.
=c. Remove Battery.= Raise saddle and bar assembly. Release and remove swivel pin. Loosen wing thumb nuts on box top hold‐down studs sufficiently to disengage bracket slots, then lift off box cover. Disconnect positive and negative wires from battery terminals. Lift battery upward out of battery box.
1. SWITCH TERMINAL (Three Wires connected)—=Black= wire from blackout marker light 24; taillight cable =green= wire from blackout taillight 22; single wire direct from blackout headlight as shown by dotted line in illustration 43, or horn and headlight cable =black= wire from junction terminal 35 as shown in illustration 44.
2. SWITCH TERMINAL (Four wires connected)—Generator and relay cable =green= wire from “=switch=” terminal (14) of generator; taillight cable =black= wire from service stop and taillight (23); horn and headlight cable =red= wire from junction terminal 17; =black= wire from speedometer light (11).
3. SWITCH TERMINAL (Two wires connected)—Generator and relay cable =red= wire from terminal marked “BAT” on relay; coil and battery cable =red= wire from junction terminal 18.
4. SWITCH TERMINAL (One wire connected)—=Black= wire from oil signal light terminal (10).
5. SWITCH TERMINAL (One wire connected)—Taillight cable =yellow= wire from blackout stop lamp (21).
6. SWITCH TERMINAL (One wire connected)—Battery and coil cable =black= wire from junction terminal 19.