SS Ancon was an American cargo and passenger ship that became the first ship to officially transit the Panama Canal in 1914 although the French crane boat Alexandre La Valley completed the first trip in stages during construction prior to the official opening. The ship was built as Shawmut for the Boston Steamship Company by the Maryland Steel Company, Sparrows Point, Maryland and put into Pacific service operating out of Puget Sound ports for Japan, China and the Philippine Islands. Shawmut and sister ship Tremont were two of the largest United States commercial ships in service at the time and the company eventually found them too expensive to operate.
Shawmut and Tremont were acquired by the United States Government through the agency of the Panama Railroad Company's Panama Railroad Steamship Line, whose assets were entirely owned by the government and critical to construction of the canal, to serve between New York and the Atlantic terminus during canal construction. Both ships were renamed for features of the canal; Shawmut for the Pacific side terminus Ancon and Tremont as for the Canal's Atlantic port. Though not the first vessel to make a complete transit, Ancon made the first official and ceremonial transit with a delegation of some two hundred dignitaries aboard. After the end of World War I the ship saw very brief service from 28 March to 25 July 1919 as a commissioned United States Ship, USS Ancon (ID-1467), making two round trip voyages from the New York Port of Embarkation to France returning troops home. Ancon was returned to Panama Canal service and was in service with the canal until 1939 when the ship was sold to private parties known as the Permanente Steamship Company and renamed Permanente.
Construction and design
The steamer was constructed by Maryland Steel, Sparrows Point, Maryland, for the Boston Steamship Line as the SS Shawmut launched December 1901 and completed in 1902. The launch date is given as "today" in a piece in The New York Times datelined December 21, 1901, and published on 22 December while the journal Marine Engineering gives the date as 23 December.
Commercial service
Shawmut was put into service by the Boston Steamship Company in association with the Northern Pacific and Great Northern Railways acting as booking agents with monthly passenger and freight sailings from Puget Sound ports of Tacoma and Seattle, Washington and Victoria, British Columbia to Yokohama, Kobe and Moji, Japan; Shanghai and Hong Kong, China and Manila, Philippines.
Shawmut's maiden voyage led to questions about whether such large ships could be profitable with specific questions concerning even larger ships being built by James J. Hill for trans Pacific trade. The ship had arrived in Seattle to begin loading for the voyage on 22 July 1902 sailing for Tacoma on 25 July to load cargo, largely of lumber that had to be transshipped due to the fact the ship was too large to enter the lumber port, and took until 22 August to fully load cargo from scattered origins. She sailed on 22 August with a stop at Seattle before proceeding to sea that night and reached Yokohama 12 September unloading a small consignment. The lumber was destined for Shanghai, but the ship was too large to reach the docks on arrival 20 September and had to unload by lighter taking until 13 October before departure for Hong Kong. On reaching Hong Kong 18 October where there was little cargo to load and only a small amount to carry on to Manila upon departure 8 November. By 22 November Shawmut was in Yokohama for a final stop before departure for Seattle on 23 November where she arrived 8 December, 139 days for the voyage. The ship had carried a then record breaking 13,000 tons of cargo, but returned with only about 2,500 tons and an estimated deficit of over $21,000 for the trip. There was speculation that Hill had used a Boston company to "experiment" on using large ships for the trade before committing his vessels.