The direct nose is interchangeable with a speed reduction gear so that the propeller can be driven at a lower speed than the engine. Fitting this gear nose raises the center line of the propeller-shaft some 5¼ in. The gears are carried on substantial ball bearings, plain bearings being used also in such a way that they take up the load if the ball bearings through any cause should fail. The reduction is by means of silent chains. The arrangement of the gear wheels is plain from the drawing, and it will be noticed that there is no intermediate wheel between the crankshaft pinion and the camshaft wheel, which are of steel and phosphor bronze respectively. A separate gear wheel is provided on the camshaft for driving the magneto. The water and oil pumps are carried low down outside the crank case, and are driven by intermediate wheels at double the engine speed. The shafts are joined together through Oldham couplings, so that it is possible to remove the pumps separately. Both these pumps are of the gear type.
The camshaft is made in one piece with the cams, and is hardened, being drilled out for lightness. It is enclosed in a casing of steel tube, which is practically separate from the crank case, being attached thereto at one end by the timing gear case and at the other by a saddle. The camshaft is carried in six bearings. An interesting point is the fact that the gear wheels are bolted to flanges on the shafts instead of being attached by keys. Carried in the tube directly above the camshaft is a second shaft forming the fulcrum of the rocking arms for the cam rollers. A very interesting point is the provision of an arrangement for lifting the exhaust valves. The little rocking arms carrying the rollers which bear upon the cams are provided with webs, parallel with the camshaft and between it and the shaft carrying the rockers is a third shaft, the sides of which normally just clear the webs of the rocking arms on either side. This shaft is provided with wedge shape pieces along it, so that by sliding it along the wedges lift the rocking arms clear of the cams, and thus, through the tappet rods and rockers, the valves themselves are opened.
Not the least interesting particular of this engine is the thorough way in which the lubrication is carried out. Four of the bolts which attach the caps of the main bearings are prolonged through the bottom of the crank case, and serve to carry a detachable oil sump which holds sufficient oil for a run of six hours. As already mentioned, the oil pump is driven at twice the engine speed, and maintains a pressure of something like 110 pounds per square inch. It delivers directly into a straight steel tube placed along the bottom of the crank case, and from this tube a vertical tubular connection is taken to each of the caps of the main bearings. The crankshaft and crank pins are hollow, and, as in the previous engine, in the hollow portions tubes of a slightly smaller diameter are placed, the tubes being expanded over at the ends, so that closed annular spaces are formed which are used as lubrication leads. The lubricating oil passes through the main bearings into these annular spaces in the shafts, from them to the annular spaces in the crank pins, and so to the big-end bearings. From the big-end bearings it travels up the connecting rods to the gudgeon pins. It is interesting to note at this point that the connecting rods work in slots in the crank case which just allow sufficient clearance for their travel, in order to prevent the flooding of oil into the cylinders. A steel-lined oil lead is taken up to the saddle which supports the tubular camshaft casing at the propeller end of the crank case. The bearings carrying the camshaft are cut away at their lower edges clear of the tube so that the oil can flow along the full length of the casing, the level being sufficient to allow the cams to dip. Precautions are taken to keep oil from flowing out of the bearings, and the casing over the gears is specially arranged to prevent the oil from flooding below.