Explorer 32, also known as Atmosphere Explorer-B (AE-B), was a NASA satellite launched by the United States to study the Earth's upper atmosphere. It was launched from Cape Canaveral on a Delta C1 launch vehicle, on 25 May 1966. It was the second of five "Atmosphere Explorer", the first being Explorer 17. Though it was placed in a higher-than-expected orbit by a malfunctioning second stage on its launch vehicle, Explorer 32 returned data for ten months before failing due to a sudden depressurization. The satellite reentered the Earth's atmosphere on 22 February 1985.

Background

Explorer 32 was built by Goddard Space Flight Center, as a successor to Explorer 17, which it strongly resembled, to directly measure the temperature, composition, density, and pressure of the upper atmosphere. Its main differences from the prior satellite were the addition of a tape recorder for data storage, solar cells to charge onboard batteries, a magnetic torquer to stabilize the satellite's spin, and a 3-axis fluxgate magnetometer for sensing the satellites aspect (facing) in orbit.

Explorer 32

Spacecraft

Explorer 32 was a stainless steel, vacuum-sealed sphere, of in diameter. It carried one ion spectrometer, two neutral mass spectrometers, three magnetron density gauges, and two electrostatic probes. It used a tape recorder to save data that was acquired when the satellite was not in range of one of the 13 ground stations. It was powered by silver zinc batteries and a solar cell array mounted on the satellite exterior.

Explorer 32

Experiments

Electron Temperature and Density

The objective of this experiment was to measure the distribution of electron temperature and densities from 10.E3 to 10.E6 electrons/cc using a swept voltage electron probe.

Explorer 32

Ion Mass Spectrometer

This experiment was designed to obtain a description of the concentrations of the ion species in the topside ionosphere (principally atomic hydrogen, helium, nitrogen, and oxygen), as a function of time, location, and solar and geomagnetic activity.

The spectrometer sensor consisted of a 5-3 cycle ceramic tube with 5-mm grid spacing and an external guard ring assembly. Two RF frequencies, 3.7 and 9.0 MHz, were used with a trapezoidal-shaped sweep voltage to cover the ion mass range 12 to 19, and 1 and 4 atomic mass units (u) assuring detection of the primary ionic constituents of the topside ionosphere. An experiment turn-on consisted of one complete mass scan in 208-seconds followed by recycling of the sweep voltage and a second measurement of the high mass range. The stopping potential and the guard ring potential controlled the sensitivity of the spectrometer, and each voltage was commandable from the ground. The ion current reaching the spectrometer was measured by a series of five-decade amplifiers with a particle sensitivity range of from about 10 x 1.E6 ions/cc. An automatic calibrator functioned once during each turn-on to supply two known signals to the amplifier system and to the sweep monitor. Amplifier characteristics were calculated from the response to these pulses. The spectrometer tube was mounted on the equator of the almost spherically shaped spacecraft. The spacecraft spin period and attitude were magnetically controlled so that the spin axis remained essentially normal to the orbit plane and, consequently, the spectrometer orifice was aligned with the satellite velocity vector once each rotation. The spin rate was 29 ±1 rpm. Since the mass range was scanned slowly compared with the spin period, each peak in the ion spectrum was modulated at the spin frequency, with the ion current maxima occurring when the angle between the spectrometer axis and velocity vector was a minimum.