The motor shown in Fig. 10 does not in any way resemble an electric railway motor, nevertheless the principle of action is precisely the same in both. The design of a machine of any kind has to conform to the practical requirements, and this is true of railway motors, just as it is true of printing presses, sawmills, or any other mechanism. A railway motor must be designed to run at a comparatively slow speed and to develop a strong rotative force, or torque, as it is technically called. It must also be so constructed that it will not be injured if covered with mud and water. It must be compact, strong, and light, and capable of withstanding a severe strain without giving out. To render the machine water- and mud-proof it is formed with an outer iron shell, which entirely incases the internal parts. The first railway motors were not inclosed, and the result was that they frequently came to grief from the effects of a shower of mud. When the modern inclosed type of motor, which is called the iron-clad type, first made its appearance it was frequently spoken of as the clam-shell type, and the name is not altogether inappropriate, for while the outside may be covered with mud to such an extent as to entirely obliterate the design, the interior will remain perfectly clean and dry, and therefore its effectiveness will not be impaired.

[Illustration: FIG. 15.--EXTERNAL VIEW OF ELECTRIC RAILWAY MOTOR MOUNTED UPON CAR-WHEEL AXLE.]

Appletons' Popular Science Monthly, January 1900 — Part 30

To enable the motor to give a strong torque and run at a slow speed the number of poles in the field and armature is increased. The design of Fig. 10 has two poles in the field and two in the armature, and is what is known as the bipolar type. Machines having more than two poles in each part are called multipolar machines. The number of poles can be increased by pairs, but not by a single pole--that is, we can have four, six, eight, or any other even number of poles, but not five, seven, or any odd number. This is owing to the fact that there must always be as many positive as negative poles, no more and no less. Railway motors at the present time are made with four poles. The external appearance can be understood from Fig. 15, while Fig. 16 and Fig. 17 will serve to elucidate the internal construction. In Fig. 15 the motor casing is marked _M_, and, as will be seen, it forms a complete shell. The motion of the armature shaft is transmitted to the car-wheel axle _F_ through a pinion, which engages with a spur gear secured to the latter. In Fig. 16 the pinion and gear are marked _N_ and _L_ respectively. As it is necessary that the armature shaft and the axle be kept in perfect alignment, the motor casing _M_ is provided with suitable bearings for both, those for the armature shaft being marked _P P_ in Fig. 16, and one of those for the axle being marked _T_ in Fig. 15. It will be understood from the foregoing that the motor is mounted so as to swing around the car-wheel axle as a center, but, as it is not desirable to have all this dead weight resting upon the wheels without any elasticity, the motor is carried by the crossbars _B B_, Fig. 15, which rest upon springs _s s_ at each end. The beam _A_ and a similar one at the farther end of the _B B_ bars extend out to the sides of the car truck and are suitably secured to the latter. The coils _w w_ are the ends of the field coils and the armature connections, and to these the wires conveying the current from the trolley are connected. The cover _C_ on top of the motor at one end closes an opening through which access to the commutator brushes is obtained. The armature is shown at _H_ in Fig. 16 and the commutator at _K_ in the same figure. Directly under the armature may be seen one of the field magnet coils, it being marked _R_.

Appletons' Popular Science Monthly, January 1900 — Part 30