Lay the edge of the rulers over the two places; then slide them (preserving the direction) till the edge of one ruler is on the center of the nearest compass; when this is done read off the course indicated by the direction of the ruler.
To measure the distance between two places on the chart spread out the dividers till their points are over them, then apply to the graduated scale at the bottom of the chart, which will give you the required distance. This method, it should be remembered, is only accurate when applied to the large coasting charts. When measuring distances on general charts which extend across many degrees of latitude, the mean latitude of the two places must be measured from.
There are certain signs and abbreviations used on charts which are easily comprehended, such as _hrd_ for hard, _rky_ for rocky, etc. Lighthouses and lightships are clearly marked, and shoals, rocks and other obstructions to navigation are plainly defined. All the marginal notes on the charts should be made familiar by the navigator. I need scarcely say that charts, instruments and books of sailing instructions should be kept dry. There are cylindrical tin boxes for charts which are quite cheap, and these I recommend.
The position of a vessel may be ascertained simply and accurately by cross-bearings. Suppose you are in a ship at _A_ in Fig. 6. The point with the lighthouse on it bears correct magnetic N. by W., and the point with the tree on it E. by N. You lay the parallel rules over the compass on your chart at N. by W., and work them to the lighthouse, preserving the direction. You then draw the line from the lighthouse to _a_. You then lay the parallel rules over the compass on your chart at E. by N., and work them in a similar way to the tree. Then draw the line from the tree to _a_. The spot where the two lines cut was the vessel's position on the chart when the bearings were first taken. The distance of the ship from both lighthouse and tree can be measured by taking in the dividers the distance between either and the ship, and referring to the scale on the chart.
It should be remembered that when sailing along the land cross-bearings will always determine your position, always allowing the proper corrections on the compass. In taking cross-bearings, try to have a difference between the two objects of as nearly ninety degrees as possible.