(24) G. W. asks: 1. Would a perfectly round ball of the same specific gravity throughout lie still on a level surface? A. Yes. 2. Can a mechanic's square be made so true that a four-inch block may be made exactly square by such an instrument? A. Yes.
(25) W. H. asks: 1. What is the weight of a boiler 24 feet long, 44 inches diameter, ¼ inch thick? A. With two flues, 16 inches diameter, 6,900 lb. 2. What is the contents (in gallons) of a tank 15 feet deep, 10 feet in diameter, top and bottom diameters being equal? Please give me a formula. A. Area of 10 feet diameter = 78.54 x 15 feet deep = 1,178 cubic feet, and, allowing 7½ gallons per cubic foot = 1,178 x 7.5 = 8,835 gallons.
(26) C. L. W. writes: I have constructed a small induction coil to be used for giving shocks. It is 3 inches long. The primary coil is wound with 3 layers of No. 18 cotton covered wire, and the secondary consists of about 12 layers of No. 38 silk covered. 1. How many cells and what kind of battery shall I use to get the best results? A. For temporary use one cell of Grenet battery would answer, but for continued use some form of sulphate of copper battery is to be preferred. 2. Is it necessary that the spring and screw in the interrupter should be coated with platinum? A. Yes; otherwise they would soon burn out.
(27) H. C. P. writes: In the Scientific American of September 18, Mr. B. Y. D., query 26, asks whether a sun dial, made for latitude 48° 15', can be utilized in latitude 38° 50' for showing correct time. To make his dial available in the lower latitudes, he has only to lift the south side, so as to give the face a slope to the north, equal to the difference of the latitude, in this case 9° 25'. For then the plane of the gnomon being in the plane of the meridian, the edge of the gnomon casting the shadow will be parallel with the earth's axis; and the face of the dial will be parallel with the horizon of the latitude for which the dial was made, and the graduation will show the time required; that is, on the supposition that it was correctly made, and for a horizontal dial.
(28) O. M. M. asks for a cheap process of plating steel case knives with tin. A. Clean the metal thoroughly by boiling in strong potash water, rinsing, pickling in dilute sulphuric acid, and scouring with a stiff brush and fine sand. Pass through strong aqueous salammoniac solution, then plunge in hot oil (palm or tallow). When thoroughly heated remove and dip in a pot of fused tin (grain tin) covered with tallow. When tinned, drain in oil pot and rub with a bunch of hemp. Clean and polish in hot sawdust.