_Vein Deposits._—In the Rosiclare district, the fluorspar and its accompanying minerals occur as steeply inclined veins a few inches to 25 feet or more wide (fig. 10), usually in limestone strata. The veins are not uniformly thick but widen or narrow from place to place both vertically and horizontally. They occur along faults—planes along which the rocks of the earth’s crust have broken and slipped. A fault may be a single plane of slippage but more often is a zone of broken and displaced rocks. In most of the faults that contain fluorspar, the slippage is vertical, or nearly so. Along one of the faults in the Rosiclare district, the rocks on one side of the fault have moved downward as much as 650 feet in relation to the rocks on the other side. Some faults are more than 10 miles long, and the depth to which they extend into the earth is unknown. Fluorspar has been mined from one of them at depths of 800 feet. Not all faults, nor all parts of any one fault, contain fluorspar.
[Illustration: Figure 10—Diagrammatic cross section of fluorspar vein along a fault. The strata on the left side of the fault have moved downward with reference to those on the right side.]

SOIL FAULT FLUORSPAR VEIN ALONG FAULT down SANDSTONE A LIMESTONE B SHALE C SANDSTONE D LIMESTONE E up LIMESTONE B SHALE C SANDSTONE D LIMESTONE E

_Bedding Deposits._—In contrast to the vein deposits of the Rosiclare district, the bedding deposits of the Cave in Rock area are flat, or nearly flat, commonly 5 to 15 feet thick, and from a few to 200 feet wide (fig. 11). They may be as much as 2000 feet long, widening or narrowing and thickening or thinning throughout their extent. They are called bedding deposits because they lie along the beds or layers of the limestone in which they occur. Most of the ore bodies are associated with a fracture or a small fault.

[Illustration: Figure 11—Diagrammatic cross section of bedding deposit of fluorspar, lead, and zinc ore.]
SOIL SANDSTONE AND SHALE ORE LIMESTONE FRACTURE OR SMALL FAULT
_Grades and Uses of Fluorspar._—There are three principal grades of fluorspar—metallurgical, acid, and ceramic. The metallurgical spar is used as a flux in making steel and in metal foundries. Acid spar is used to make hydrofluoric acid, which plays a part in the preparation of uranium isotopes and in the production of a synthetic mineral essential in refining aluminum. The acid is also used in the production of high-octane gasoline and is the basis for a variety of important chemical compounds, among them refrigerants and insecticides. Ceramic grade fluorspar is used in making enamels, glazes, and certain kinds of glass.





