_Man-holes_--Are large openings into the interior of a boiler, through which a man may pass to clean out the inside.
_Hand-holes_--Are smaller holes at various points in the boiler into which the nozzle of a hose may be introduced for cleaning out the interior. All these openings must be securely covered with steam-tight plates, called man-hole and hand-hole plates.
_A boiler jacket_--A non-conducting covering of wood, plaster, hair, rags, felt, paper, asbestos or the like, which prevents the boiler shell from cooling too rapidly through radiation of heat from the steel. These materials are usually held in place against the boiler by sheet iron. An intervening air-space between the jacket and the boiler shell will add to the efficiency of the jacket.
_A steam-jacket_--A space around an engine cylinder or the like which may be filled with live steam so as to keep the interior from cooling rapidly.
_Ash-pit_--The space directly under the grates, where the ashes accumulate.
_Dead-plates_--Solid sheets of steel on which the fire lies the same as on the grates, but with no openings through to the ash-pit. Dead-plates are sometimes used to prevent cold air passing through the fire into the flues, and are common on straw-burning boilers. They should seldom if ever be used on coal or wood firing boilers.
_Grate Surface_--The whole space occupied by the grate-bars, usually measured in square feet.
_Forced Draft_--A draft produced by any means other than the natural tendency of the heated gases of combustion to rise. For example, a draft caused by letting steam escape into the stack.
_Heating Surface_--The entire surface of the boiler exposed to the heat of the fire, or the area of steel or iron sheeting or tubing, on one side of which is water and on the other heated air or gases.
_Steam-space_--The cubical contents of the space which may be occupied by steam above the water.
_Water-space_--The cubical contents of the space occupied by water below the steam.
_Diaphragm-plate_--A perforated plate used in the domes of locomotive boilers to prevent water dashing into the steam supply pipe. A dry-pipe is a pipe with small perforations, used for taking steam from the steam-space, instead of from a dome with diaphragm-plate.