(129) The machine made by Messrs. Ashworth Bros., of which a perspective view was given in Fig. 44, is based upon an entirely different principle. Before passing on to describe it, it is only fair to say that to this firm belongs in great measure the great advance which has been made in the construction of this form of machine. They recognised the importance of accurate mechanical construction, with the result that they produced a machine which could be run at much higher velocities than had hitherto been thought possible. Referring now to Fig. 64, on the top of the fixed bend =B=, a number (about 15) of thin steel bands =E= are placed, being held at one end by the stud =G= and kept in tension by the screw =C=, thus being firmly drawn into position. The bands are of various thicknesses, from 1/30th to 1/100th inch. The end of the flat traverses on the top band =F=, and any of them can be removed and replaced by a thinner one. Thus the concentricity of the flat course is preserved, provided that the amount of wear to be taken up corresponds with the difference between the thickness of the band taken out and that replacing it. It may happen that the amount of wear to be provided for is not enough to justify the removal of the band, which, on account of the necessary labour involved, takes some little time. In order to afford a ready means of making the correction, and at the same time avoiding the replacement of the bands, the makers have adopted the bold but ingenious plan of forming the cylinder bearing so as to be adjustable vertically. Referring now to Fig. 64 it will be noticed that the engine bend and the pedestal are cast in one piece, bolted on to the lower frame. The pedestal cap is fastened by means of set screws, but the bottom brass can be lifted by means of the vertical screw shown in dotted lines. This screw is fitted into the pedestal, which is tapped to correspond, and has at its lower end a ring which is divided into 100 parts on its circumference. An indicator finger is fitted so that the ring can set to any of the divisions as desired, and when so set the screw can be locked by a lock nut. By proportioning the pitch of the thread it is clear that any desired lift can be obtained. The pitch adopted being 1/10th of an inch, a revolution of the screw one division on the ring would mean a vertical movement equal to 1/1000th of an inch. Now it is quite true that in a sense any vertical movement of the cylinder destroys the concentricity of the flats, but this, after all, is a relative matter. If reference is made to a drawing showing the arc occupied by the flats in various positions, it will be seen that with a total fall of 3/8ths of an inch the difference between the ends and centres of the arcs described does not amount to a great deal. Therefore if the cylinder was raised by the screw about 1/8th inch it would not amount to an inaccuracy of any magnitude. But as the thickest band is only 1/30th of an inch thick it would be most likely that instead of lifting the cylinder anything like 1/8th inch a band would be taken out and the wear thus compensated for. The raising of the cylinder 1/30th of an inch would practically mean that the setting of the flats would remain unaltered.