The cylinder has a bushing, which projects in front of it, and gives three surfaces upon which the cylinder revolves, thus diminishing the chance of sticking from dirt or rust, and also giving a very small axis upon which to revolve, decreasing the moment of friction.
When the ejector is used it springs back to its place and is ready for use again, avoiding the necessity of putting it back.
TO TAKE APART THE REVOLVER.--Half-cock the revolver, loosen the catch-screw which holds the centre-pin, draw out the centre-pin, open the gate, and the cylinder can then be withdrawn.
To remove the ejector, turn out the ejector tube screw, then push the front end away from the barrel and pull it towards the muzzle. The barrel can then be unscrewed.
The stock can be removed by turning out the two screws just behind the hammer, and that at the bottom of the strap. All the parts of the lock are then displayed, and can be readily separated.
The cylinder bushing should be pushed out for cleaning.
To remove the gate, turn out a screw in the lower side of the frame (hidden by the trigger-guard), then the gate-spring and catch can be withdrawn, and the gate can be pushed out. The best sperm-oil should be used for oiling the parts.
TO LOAD THE ARM.--1st motion: holding the revolver in the left hand, muzzle downwards, half-cock it with the right hand and open the gate. 2d motion: insert the cartridges in succession with the right hand, close the gate, cock and fire it (taking it in the right hand), or bring the hammer to the safety-notch, as may be desired.
TO EJECT THE CARTRIDGE SHELLS.--1st motion: holding the arm in the left hand, half-cock with the right hand and open the gate. 2d motion: eject the shells in succession with the ejector pushed by the right hand, moving the cylinder with the thumb and forefinger of the left hand. When the shells have been ejected, the pistol is ready for the 2d motion of loading.
There are three notches in the hammer of this arm. The first is the safety-notch, the second is the half-cock notch, and the third is the cock-notch. The pistol cannot be fired when the hammer rests in the safety-notch or half-cock notch, and can be fired by pulling the trigger when the hammer rests in the cock-notch. The pistol should be carried habitually with the hammer resting in the safety-notch.