We give one more method of finishing black walnut, that is, with boiled linseed-oil only, and there is no other way of obtaining a genuine oil-finish. Sand-paper the wood down smoothly; apply a coat of boiled linseed-oil over the whole surface; sand-paper well, and clean up dry with rags; let it stand one day to dry, then apply one more coat of oil; rub well in with rags, but do not use sand-paper on this coat. Apply three, four, or more coats in the same way. When the work has received the last coat of oil and is dry, sand-paper down with old paper. Then clean up with the best coach japan with rags, and let the work stand one day to dry. The panels are to be varnish-polished the same as other wood. The work is then finished, and ready for the warerooms.
This method takes a longer time than finishing with either varnish or shellac; but the cost is less both for materials and for labour, the workman being able to go over a greater surface in the same time. The work will stand longer, and the method gives a rich and close finish, bringing out the figure and rich colour of the wood better than in any other method of finishing. It does not cost so much as shellac finish; it only requires a little more time for drying between the coats of oil. In finishing in varnish or shellac, to get the body or surface for polishing three or four coats are frequently applied, which is liable to produce a dull cloudy appearance. For this reason, and having in view the high and increasing price of stock, it seems to us that this really superior method of finishing in oil must take the place of shellac and varnish-finish in good work.
=Polishing Varnish.=--This is certainly a tedious process, and considered by many a matter of difficulty. The following is the mode of procedure: Put two ounces of powdered tripoli into an earthen pot or basin, with water sufficient to cover it; then, with a piece of fine flannel four times doubled, laid over a piece of cork rubber, proceed to polish your varnish, always wetting it well with the tripoli and water. You will know when the process is complete by wiping a part of the work with a sponge and observing whether there is a fair and even gloss. Clean off with a bit of mutton suet and fine flour. Be careful not to rub the work too hard, or longer than is necessary to make the face perfectly smooth and even. Some workmen polish with rotten-stone, others with putty-powder, and others with common whiting and water; but tripoli, we think, will be found to answer best.