UNEVEN OPACITY OR DENSITY, varying gradually from one end or side of the plate to the opposite end or side, is due to uneven coating of the plate. If there is a distinctly defined patch, less opaque than the rest, the plate was not properly covered by the developing solution.
STAINS.--A uniform stain, of a yellowish or brown colour, is produced when the pyro developer contains too small a proportion of sulphite or is allowed to act for a very long time. Such a stain is rarely observed with the other developers mentioned above. The pyro stain can be more or less completely removed by immersing the plate for some time, with repeated rocking, in the alum solution given above, 1 drachm of sulphuric acid being added to every 10 ounces. The plate must afterwards be well washed in soft water. Similar stains in patches may be caused by using dirty dishes or a developer that has become turbid by being frequently used.
DEEP YELLOW-ORANGE OR BROWN STAINS, appearing gradually in patches or all over the negative, some time after it has been fixed, and washed, and dried, are due either to imperfect fixing or to incomplete washing after fixing. There is no practicable remedy.
HALATION.--When the subject photographed includes some part much more brightly lighted than the rest, such as a window in an interior subject, the details of the bright part are not only lost, but the image of it seems to spread in all directions, obliterating the details of the surrounding portions. The effect is especially noticeable when the subject includes dark parts which necessitate a somewhat long exposure. A window at the end of a long dimly lighted interior, or dark trees against a bright sky are cases in point. The effect is really due to the fact that the sensitive film is not perfectly opaque, and some of the incident light passes through the film and is reflected from the back surface of the glass on to the under side of the film, producing a blurred image superposed, as it were, on the normal image formed at the surface of the film by the action of the direct light. The effect is known as "halation." It is prevented by having a perfectly opaque film, which is a condition difficult to realize in practice, and which, moreover, introduces certain other disadvantages. It is also prevented by coating the back of the plate with some substance that will absorb the rays that have passed through the film, and so prevent their being reflected back against the under side of the film. The substance used must either be opaque or must have a deep orange, brown, or red colour, and it must have the same refractive index as the glass, otherwise the reflection will not be prevented. For practical convenience it must also be easily applied and easily removed. Many substances have been recommended but nothing is so good as caramel, prepared by the action of heat on sugar. In order to get the mixture to dry completely after it has been applied, a somewhat troublesome process of purification is necessary, but caramel specially prepared for the purpose can now be obtained from dealers in photographic materials. The caramel (which is a solid substance) is dissolved in just enough water to make a thick syrup, which is carefully applied to the back of the plates in a thin layer by means of a flat brush.