[Illustration: FIG. 7. The maxillo-palatal-pterygoid arch of _Conophis lineatus concolor_ (UMMZ S-788) showing (A) dorsal, (B) lateral, and (C) ventral views. × 3. Teeth shown by means of broken lines were represented only by their sockets.]
_Maxillo-palatal-pterygoid arch._--In an articulated skull, the anterior edge of the maxillary is immediately posterior to the lateral tip of the premaxillary (fig. 7). The maxillary is curved moderately laterally and is not robust at its tip, but it becomes heavier about one-third of its length posteriorly. A dorsomedian process begins at about one-third of its distance from the anterior end; the prefrontal articulates with this process. The process is broad and almost flat, except that at its medial end, an elongate, rounded knob extends ventrally. The dorsomedian process of the maxillary extends toward, but does not meet, a lateral process from the palatine. The maxillary teeth are set in sockets on the ventral surface of the bone. Just posterior to the level of the last prediastemal tooth is the median trans-palatine process that articulates with the anteromedian part of the trans-palatine. Immediately posterior to this process, the maxillary narrows slightly; then it broadens to form an obliquely oriented knob. The posteroventral surface of the posterior knob of the maxillary bears one or two enlarged maxillary teeth. (These teeth are discussed further in the section on Dentition.) The anterolateral part of the trans-palatine articulates with the dorsal surface of the posterior knob of the maxillary. Toward the middle of its length, the trans-palatine narrows considerably; then it broadens again and articulates with the pterygoid. The palatine is slightly rounded at its anterior end, which extends anteriorly to the posterior margin of the vacuity containing Jacobson's organ. The palatine extends posteriorly to the trans-palatine process of the maxilla, where the palatine articulates with the pterygoid. A posterior pterygoid process from the palatine projects posteromedially from the end of the palatine and overlaps the anterior end of the pterygoid. Just less than one-half the distance from the anterior end of the palatine, there is a lateral process that curves ventrolaterally forming a blunt tip posteriorly. Slightly more posteriorly and on the medial side of the palatine, is a medial sphenoid process, which is thin, rather broad, and curves ventromedially; ultimately it comes to lie near the anterior part of the parasphenoid. The palatine teeth are set in shallow sockets on the ventral edge of the bone. Of the bones of the maxillo-palatal-pterygoid arch, those on the pterygoid extend farthest posteriorly. The pterygoid is broad medially and posteriorly, although pointed at its posterior tip. The trans-palatine articulates in a broad line at about one-third of the distance along the lateral margin of the pterygoid. Immediately posterior to this articulation, there is a median ridge on the pterygoid; lateral to the pterygoid ridge is an abrupt hollow, the pterygoid groove. Posteromedially, this groove becomes gradually more shallow and disappears. The dorsal surface of the pterygoid is rounded anteriorly and somewhat flattened posteriorly, whereas the ventral surface is gently rounded along its length, except that there is a high median crest. The pterygoid teeth are situated in shallow sockets along this crest. The teeth diminish in size posteriorly.