The ferricyanide reducer can be applied locally for reducing high-lights, halated windows, etc., and this is often very valuable, especially in the case of under-exposed negatives. A small quantity of hypo and ferricyanide solution is mixed in a measuring glass or some other suitable vessel. The plate is immersed in plain hypo solution in a white dish for a short time and is then raised by one corner or one edge until the part to be reduced is above the solution. The mixture of hypo and ferricyanide is carefully applied with a camel's hair brush to the parts that are too opaque, and after a few moments the plate is allowed to slip back into the hypo solution and the dish is rocked. If the reduction is not sufficient, the same proceeding is gone through as often as necessary. The reducer should not be allowed to act too long before putting the plate back into the hypo, otherwise the reduction may spread further than is desired. Further, the reducer must not be too strong (_i.e._, contain too much ferricyanide), otherwise it will produce brownish stains and the action may be too energetic.
The other reducer is known as Belitzski's reducer, and is made up as follows:--

Ferric potassium oxalate 1 oz. or 5 parts[5] Sodium sulphite 1 oz. or 4 parts Oxalic acid 1/4 oz. or 1 part Hypo solution (25 in 100) 5 oz. or 25 parts Water 20 oz. or 100 parts

[5] The formula in "parts" does not strictly correspond with that in ounces, but the difference is immaterial.

The constituents must be dissolved in water in the order given. The solution can be used at once and it keeps fairly well if protected from light, in well corked bottles filled up to the neck.
Intensification is a process in which the opacity of the image is increased by adding some fresh matter, metallic or otherwise, to the reduced silver that constitutes the developed image.
The usual plan is to bleach the image by means of a solution of mercuric chloride (mercury perchloride or corrosive sublimate), which converts the dark-coloured silver into a white mixture of silver chloride and mercurous chloride, and this is subsequently treated with some re-agent which will reconvert the image into a dark product of greater opacity than the original.





