“Chocolats fondants” are from a gastronomic point of view, the finest chocolate product on the market, and it is not remarkable that this branch of the chocolate manufacture has witnessed a considerable extension, and is likely to extend still more.
The manufacture of chocolate has been very considerably facilitated by the introduction of heating chambers and closets, which have now become an indispensable feature of every factory in the industry. In these chambers the chocolate which has still to be rolled, as well as that already submitted to this operation, is stored and kept at a temperature of 60° C. until it can be further treated (moulded). This manner of heating involves an appreciable cheapening of the production, for masses which are dry and apparently require an addition of fat recover in such a manner during a twenty four hours’ storing in the heating chambers that such addition becomes unnecessary. But especially when chill casting rollers are employed, which the mass leaves in a very dry state, the use of these heating chambers is indispensable. They should be available in every factory to such an extent as to find room for the total output of one day, though even twice or three times this amount might very well be provided for. Closets heated by steam are best adapted for small factories, such as are illustrated in Fig. 45. They possess double doors, are walled in, and are capable of holding from 300-400 kilos of chocolate mass for each metre of length. Larger factories should furnish themselves with chambers, which are more open to access and on the walls of which iron shelves can be introduced, heated by steam pipes arranged underneath. A typical chamber, measuring 2·8 metres in breadth (including passage) and 5 metres in length would hold about 2,500 kg of chocolate.
After emerging from the final rolling process, the chocolate is stored up in heating chambers until it is ready to succeed to the moulding, prior to which, however, it must be freed from air and cut up into small portions. Until recently, it usually came next in a melangeur provided with a dish-shaped bed-stone made of granite, as illustrated in fig. 46, where it was kneaded and reduced to a uniform plasticity and heated to the temperature required for moulding. The melangeurs devoted to this purpose are now superseded by special tempering machines.