"A simple and efficient form of sterilizer consists of a wooden trough provided with a wooden grating which is raised 2 inches from the bottom and on which rest the filled bottles in wire baskets. The trough contains enough water to submerge the bottles and is kept at a temperature of 185° F. by means of a steam coil beneath the grating. It requires about 15 minutes for the must at the bottom of the bottles to reach that temperature; for packages of other sizes it is necessary to make a test with a thermometer in order to determine how long it takes for the entire contents to reach 185°.
"To prevent the corks from being expelled during sterilization, they are either tied down with a strong twine or with some contrivance such as the cork holder. In order that mold germs may not enter the must through the corks, especially if a poor quality of cork is used, the necks of the corked bottles are dipped in heated paraffin before putting on the caps, or the corks are sealed down with sealing wax. It is also well to keep the bottles on their rider to prevent the corks drying out."
The principles involved in making grape-juice in the home are the same as those used in canning. The grapes may be crushed by hand or in mills similar or identical with the small cider-mills owned by many farmers. In making a light-colored juice, the crushed grapes are put in a cloth sack and hung up to drain, or the filled sack may be twisted by two persons until the greater part of the juice is expressed. The juice is then sterilized in a double-boiler by heating it at a temperature of 180° to 200° F., care being taken that the thermometer never goes above 200°. The sterilized juice is now poured into a glass or enameled vessel to stand for twenty-four hours, after which it is drained from the sediment and strained through several thicknesses of clean flannel. The juice is now put in clean bottles preparatory to a second sterilization, care being taken that at least an inch of space is left at the top for the liquid to expand when heated. The second sterilization may be conducted in a wash-boiler or similar receptacle. The filled bottles must not rest on the bottom of the boiler but should be separated from it with a thin board. The boiler is filled with water up to within an inch of the tops of the bottles and heated until the water begins to boil. The bottles should then be taken out and corked immediately, using only new corks. After corking, the bottles are further sealed by dipping the corks in melted paraffin. A cheap corking machine is a great convenience in this work, and in any case the corks should be soaked for at least a half hour in warm but not boiling water.