Q. What would you do if you discovered the water gone from sight in the water glass?

A. Pull the fire or cover it over with dry ashes, and allow the boiler to cool off as quickly as possible; and would not open or close any of the steam outlets.

Young Engineer's Guide — Part 76

A. A traction engine is an engine the power of which is transmitted to the driving or ground wheels by a combination of gearing.

Young Engineer's Guide — Part 76

A. The pipe through which the exhaust steam escapes from cylinder to smoke stack.

Young Engineer's Guide — Part 76

A. The pipe through which the feed water passes from pump or injector to the boiler.

A. The pipe through which steam is taken from the dome to the steam chest.

A. A small cock used in check valves, pipes and places where draining off water is necessary to prevent freezing.

Q. What is clearance in a steam cylinder?

A. It is the space between the cylinder head and piston head when the latter is at end of the stroke.

Q. What is “cushion” in a steam cylinder?

A. Cushion is the compression of steam let in through the lead of the valve in the clearance of the cylinder, and is for the purpose of catching the weight of the piston and rod, cross-head and connecting rod when the engine reaches the end of each stroke. It also keeps the engine from pounding.

Q. How much water would you blow off at any one time while running?

Q. What are your general views regarding boiler explosions?

A. The greatest causes are from ignorance, carelessness and neglect.

Q. What precaution should you take if necessary to stop with a heavy fire in the furnace?

A. Close the draught door, and put the injector or pump at work.

Q. What is the proper height to carry water in the boiler?

A. About 2½ inches above top row of flues.

Q. At what pressure should you blow off a boiler?

A. At a pressure not to exceed ten pounds.

Q. If you wished to increase the power of an engine what would you do?

A. Increase its speed or get higher steam pressure.

Q. How do you find the horse-power of an engine?

A. Multiply the speed of piston travel in feet per minute by the total effective pressure upon the piston in pounds, and divide the product by 33,000.

A. Brass bound means that the half brasses touch each other and cannot be driven up any closer by the key.

Q. How would you remedy a brass bound box on crank-pin or wrist-pin?