Amongst the principal machines used in this tool-manufacturing department is an 8-in. Whitworth self-acting, sliding-surfacing, and screw-cutting lathe, with a backing-off and taper-turning attachment. The milling, drilling, and grinding machines are all by the best makers. A 10-ft. machine is used for making the comparative measurements from existing standards. This machine, also of Whitworth make, has a measuring screw in a fast headstock with a large dividing wheel, one division of the latter representing 0.0001-in. in the end movement of the spindle. All transverse and tensile testing of bars is done in this department.

A check system is used in connection with the distribution of templates, tools, drawings, etc., and a separate store in the centre of the works is arranged for this purpose.

Two Centuries of Shipbuilding — Part 80

[Illustration: HYDRAULIC PLATE-BENDING MACHINE.]

Two Centuries of Shipbuilding — Part 80

As to the boiler works, the fact that in 1905 the production was practically one boiler per week is, of itself, testimony to the nature of the plant adopted. The main boiler shop, together with its yard, has an area of 7000 square yards, and a height of 45 ft. to the crane rail, and is served by five overhead electric cranes, ranging in lifting power up to 100 tons, with numerous jib and other cranes associated with the various machine tools.

Two Centuries of Shipbuilding — Part 80

[Illustration: Plate LIV. IN THE BOILER SHOP.]

The machine tools fitted in the boiler works are all of a very powerful character; but only a few of these need here be referred to. There is a 13-ft. gap hydraulic plate-bending machine, which is entirely automatic in its action, and can be set to any radius to bend plates up to 2 in. thick when cold. The flanging for the front and back plates of boilers is done in an hydraulic machine, exerting a pressure of over 160 tons. This machine has four rams, two of which act downwards, one upwards, and the other horizontally. It is served by a special hydraulic jib-crane, capable of lifting the heaviest plates. There are also plate-edge planers and triple boring mills of corresponding power, while the vertical rolls take in plates up to 10-ft. wide.

For the riveting of the boilers there is a 13-ft. gap hydraulic riveting machine, capable of exerting a load on each rivet of 200 tons. The weight of this riveting machine alone is about 60 tons, and it is served by an independent hydraulic jib-crane. All the valves in connection with the crane and riveter are led to a common platform, so that one man is able to manipulate the whole of the work.