(213) A reference to Figs. 123 and 125 will show that extending along the frame is a shaft having a hand-wheel at the end, and a number of worms keyed on it. The latter gear into worm wheels, on the axes of which cams are fixed by which a bar—through which the weight-rods pass—is lifted. As the rods have a loop at their upper end which cannot pass through the holes in the bar, it is clear that the elevation of the latter will also raise the weights. In this way the pressure on the rollers is relieved. This is of value when the frame is stopped for any prolonged period, as the maintenance of the pressure during that time results in the formation of flat places on the rollers, which are detrimental to good work. It is undesirable to put on or take off the weight suddenly, and some makers prefer to use a simple lifting appliance by which each weight can be released singly.

(214) The important features in connection with the roller portion of the mechanism are—first, their perfect finish; second, the adoption of such diameters and distances as are suitable for different lengths of staples; third, their effectual cleansing; and, fourth, the regulation of their velocity so as to suit the material being dealt with.

Modern Cotton Spinning Machinery — Part 99

(215) It was pointed out in paragraph 207 that there are certain irregularities in the size of the slivers, as obtained from the carding engine. Up to the present the machine has been considered as though each sliver was treated separately, a course which would result in the delivery of a sliver longer than, but possessing the same defects as, the original one. That this must be so is apparent, unless some provision is made for the acceleration of the speed of delivery when a thin place was passing, or its retardation when a thick place occurred. It therefore becomes necessary to find a method of rectifying these defects, and it is obtained by passing several slivers through the machine simultaneously. Reference is now more particularly made to Fig. 123, which shows the mode pursued clearly. A number of full cans from the carding engine—up to eight—are placed behind each delivery, and the slivers they contain are combined and passed through the rollers together. Before passing on to consider the exact effect of this arrangement, a few words may be said as to the method of feeding the cans to the machine. As each can contains approximately the same length, it follows that, the rate of passage being the same throughout the machine, they would all become empty at practically the same time. This implies the necessity for the attendant to remove the cans and piece up the new slivers all along the frame almost simultaneously. This is practically impossible, and it is therefore highly desirable that there should be an arrangement adopted which would enable the cans to be substituted at different times along the frame. In a little but valuable work, “Progress in Cotton Carding,” the late Mr. F. A. Leigh, of Boston, U.S.A., makes the following remarks: “If there are 10 pounds (or 1,000 yards), say, in a full can, instead of putting them all up full at first, it is better to put them up at back of drawing in four sections, say:—

Modern Cotton Spinning Machinery — Part 99