(245) The effect of the application of this formula in the latter case is different entirely to the results already described. If the wheel =L= revolves at the same speed as =B=, but in the contrary direction, then _n_ = - 3_b_, if the value of _b_ be substituted for that of _l_. If =L= makes half the number of revolutions that =B= does, then _n_ = -2_b_. The relations of =B= and =D N= can thus be accurately ascertained, and by the aid of this formula the speed of the bobbin wheel can be easily calculated. It is only necessary to know the value of the entire train of gearing from the fixed wheel =B= to the plate wheel =N= to be able to apply the formula given above. Thus, if it is found that the ratio of the velocity of =L= and the fixed wheel =B= be, say, as 1: 40, and that =B= makes 250 revolutions per minute, the speed of =D N= could be arrived at easily. Substituting the arithmetical value of _l_ and _b_ for those signs, the result would be _n_ = 250 - 2(250÷40) = -262·5. As the changing position of the cone strap is the only variable factor in the problem, it is only necessary to know the diameters at various points to ascertain accurately the reduction or acceleration of speed which will occur during the time it is making the necessary traverse. It should be explained, before passing on to deal at greater length with the practice of the subject, that the minus sign merely indicates that the bobbin wheel revolves in a contrary direction to the wheel =B= and the shaft =A=.

(246) The application of this mechanism to the purposes of winding depends, therefore, upon the regulation of the speed of =L=. It has been seen that the motion of the latter is derived from the bottom cone =E^{ 1}=. Assuming the plate wheel to run in the same direction as the wheel =B=, it follows that when the bobbin leads, the wheel =L= must start at its slowest relative speed, and increase as the bobbin fills. It is for many reasons desirable that the speed of the plate wheel should be as low as possible, which is the course generally adopted. If the flyer leads, the opposite plan is pursued. When, as is the case in the machine made by Mr. John Mason, the plate wheel revolves in the reverse direction to that of the wheel =B=, it commences at its quickest and finishes at its lowest relative speed, with a bobbin lead. Under these circumstances the full value of the special arrangement, illustrated in Fig. 137, is seen. The highest velocity of the cone is obtained when the bobbins are empty and have in consequence the lightest weight. Where spindles are revolving at 800 to 1,000 revolutions per minute, this is undoubtedly a great consideration, because the strain upon the strap is lessened by reason of the decreased velocity at a time when the strap is on the smallest diameter of the driving cone. It is sometimes the practice to run =L= and =D= on the bare jack shaft in the contrary direction, this creating a good deal of friction and necessitating extra driving power. For this reason the introduction of a tubular bush, such as is shown in Fig. 137, is attended with considerable advantage. The friction existing when the wheels run upon the bare shaft, but in the contrary direction, is very great, as will be understood when the speed of the wheels—about 400 revolutions per minute—is remembered. Any rotation of one or more of the wheels in the opposite direction to the shaft is therefore equal to an increase of the friction on the latter by the rate of the movement of the former.

Modern Cotton Spinning Machinery — Part 114