The Wilkinson (Black and Hawthorn) engine had a vertical boiler and machinery. The cylinders were on the opposite side of the boiler from the door of the fire box, and mounted independently; the motion of the piston was communicated by means of a crank shaft and toothed wheels to the driving axle. The wheels were coupled. A regulator, injector, and a hand-brake were placed at each end, so that the engine driver could always stand in the front, whichever was the direction in which the engine moved; and there was a platform of communication between the two ends, carried along one side of the boiler.
The boiler was constructed with "Field" tubes, the horizontal tube plate having a flue in the middle which carried the heated gases into the chimney.
The visible escape of the steam is prevented by superheating. To effect this, the steam, as it leaves the cylinder, passes into a cast iron chamber adjacent to the boiler, which is intended to retain the water carried off with the steam. From thence the steam passes into a second chamber, suspended at a small height above the grate in the axis of the boiler and of the flue which conveys the heated gases into the chimney, and thence into a sort of pocket inclosed in the last-mentioned chamber, which is open at the bottom, and the upper part of which terminates in a tube passing into the open air. This method of dissipating the steam avoids the necessity of a condenser; but if it be admitted that the steam in escaping has a minimum temperature of 572° Fahr., it will carry away 12 per cent. more caloric than would have been required to raise it to a pressure of 150 lb. per square inch.
The steam escaping through the safety valve is passed through the same apparatus.
The toothed wheel on the driving axle is arranged to act upon another toothed wheel on a shaft connected with the regulator, so as to control its speed automatically.
The length of the engine is 10 ft. 10 in., its width 5 ft. 9 in., and the distance from center to center of the wheels 5 ft. 2 in.
The Rowan tram-car consists of a body 31 feet long and 7 feet wide, resting on a two-wheeled bogie behind and on a four-wheeled bogie in front, this front bogie being the motor, and the whole has the appearance of a long railway carriage, somewhat in the form of an omnibus with a platform at each end, of which the front platform is occupied by the engine. It requires, therefore, either a turntable or a triangle at the end of the line, so as to enable it to reverse its direction.