It is well to test the skirt and waist patterns by using inexpensive materials, such as calico, gingham, or cheap lining. Cut, baste, fit, and make this as carefully as if it were the best cloth or silk. If the skirt and waist are satisfactory, the pattern will do duty for several seasons. The plain waist pattern is the foundation for _any_ waist and many changes can be made easily with a well-fitting skirt and plain waist pattern as a basis.
As paper patterns soon wear out, after a waist and skirt have been perfectly fitted, it is a good plan to cut an exact pattern of cambric, both skirt and waist, tracing seams and notching the parts. This will enable the home dressmaker to cut and make all ordinary dresses with little trouble and with but one trying on. It is always well to try on once, as materials differ in texture and a slight change may be necessary.
At the left, on plain or symmetrical designs; at the right, on figured or napped goods. _a_--Half of front gore; _b_--Second gore; _c_--Third gore; _d_--Back gore; _e_--Front waist; _f_--Under arm piece; _g_--Side back; _h_--Back; _i_--Outside sleeve; _j_--Under sleeve; _c' d'_--Piecing of gores _c, d_.]
If the material is plain, has no nap, or if the design is perfectly symmetrical, the gores may be alternated, the top of one gore coming opposite the bottom of the next. The half pattern of the front gore is always laid on a _lengthwise fold_ of the goods. If the goods is wide, the other gores may be cut double with the cloth folded lengthwise. With narrow goods, the cloth may be folded end to end after the middle gore has been cut out, and the other gores cut double. Care should be taken that the line of holes in the middle of the gores runs exactly in a line with the warp of the material, i. e., parallel to the selvage.
If the goods has a figure, the design should run upwards. Any nap should run downward, except with velvet or velveteen, in which it should run upwards. With such goods, the gores if cut double must be placed on a lengthwise fold, with the lengths running the same way. If the goods is narrow, the gores may have to be cut single, reversing the pattern (turning it over) so that both pieces may not be for the same side.