The right side of the velveteen should be carefully basted with small, even stitches to the edge of the facing. It may be hemmed to the facing or machine stitched just inside the basting, which need not be removed. It is then turned, allowing a very narrow portion to show below the edge, and basted with close stitches, pressed, hemmed down to the facing by hand, or cat stitched without turning the edge. Be careful not to let the stitches show on the right side, nor let the binding twist or pucker. The joining of the velveteen should be near the seam in the back.
Another method is to cut off the bottom edge of the skirt a quarter of an inch from the turning line; apply the wrong side of the velveteen to the right side of the skirt, baste carefully close to the edge and stitch on the machine through velveteen, cloth, and lining (or facing) just inside the basting which is left in. The bottom of the raw edge is turned up, basted close to the edge allowing the velveteen to show a very little. The upper edge of the velveteen is secured as before by turning and hemming or catstitched without turning. The illustration shows this method of applying the velveteen which is first stitched to the lining and turned with the edge. This makes a firm, rather stiff finish.
Braid is stitched on to the bottom of a skirt with a narrow edge showing, or it may be applied like the velveteen, with a doubled edge at the bottom. The doubled edge will wear better.
Skirts that are to be washed and therefore which are very likely to shrink must be finished at the bottom with a wide hem--at least six inches--the fullness made by turning being disposed of carefully in pleats or gathers.
[Illustration: APPLYING VELVETEEN BINDING]
If desired, the bias seam down the back of the skirt may have a narrow woven tape or selvage of thin goods stitched in with the seam. This strengthens the seam and prevents dragging. The skirt when finished should always be longer in front than in the back.
All cloth dresses demand every detail of finish to make them complete and able to stand hard usage, but simple house dresses and thin summer dresses do not require such careful finish.
In planning a waist the same rules should be observed in placing patterns, etc., as described for skirts, except that the lines and seams should be traced with a tracing wheel or marked carefully. In making a waist of any kind care must be taken to cut all the pieces the proper way of the material.