Vauban's "first system," as variously described by other writers even in his own time, is pieced together from some of the early examples of his work. The "second system" is the "tower bastion" defence of Belfort and Landau (1684-1688), obviously suggested by a design of Castriotto's one hundred years earlier; and the "third system" is the front of Neu-Breisach (1698), which is merely Landau slightly improved. In other works, between 1688 and 1698, he did not keep to the tower bastion idea.
It will be convenient to take the "first system," as reproduced in the Royal Military Academy text book of fortification (fig. 25) as typical of much of Vauban's work. It may be observed that he sometimes uses the straight flank, and sometimes the curved flank with orillon. Parapets in several tiers are never used, nor cavaliers. The ravelin is almost always used. It is small, having little artillery power and giving no protection to the shoulders of the bastions. Sometimes it has flanks and occasionally a keep.
The tenaille is very generally found. In this form, viz. as a shield to the escarp of the curtain, it was probably invented by him. Fig. 25 shows two forms. In both the parapet of the tenaille had to be kept low, so that the flanks might defend a breach at the shoulder of the opposite bastion, with artillery fire striking within 12 ft. of the base of the escarp. Traverses are used for the first time on the covered way to guard against enfilade fire; and the re-entering place of arms, to which Vauban attached considerable importance, is large.
[Illustration: FIG. 25.--Vauban's First System.]
For the construction of the trace an average length of about 400 yds. (which, however, is a matter entirely dependent on the site) may be taken for the exterior side. The perpendicular, except for polygons of less than six sides, is one-sixth, and the faces of the bastions two-sevenths of the exterior side. The flanks are chords of arcs struck from the opposite shoulder as centres. An arc described with the same radius, but with the angle of the flank as a centre, and cutting the perpendicular produced outwardly, gives the salient of the ravelin; the prolongations of the faces of the ravelin fall upon the faces of the bastions at 11 yds. from the shoulders. The main ditch has a width of 38 yds. at the salient of the bastions, and the counterscarp is directed upon the shoulders of the adjoining bastions. The ditch of the ravelin is 24 yds. wide throughout.