Upset one end of the shorter piece 1/8 inch larger than its diameters, and form a scarf similar to the first one for the right-angled weld, but here allow it to form fan-shaped and project equally over each edge, as shown at _a_.
Upset the center of the long piece to 1/8 inch or more larger than its diameters, with the upset portion fully 1 inch long, as at _b_. Form a scarf at this place with the ball of the hammer, allowing the metal to bend edgewise, as at _c_. Do not make this scarf quite so wide as the first one, as its edges should be entirely covered by scarf _a_ without leaving any openings. See that they fit properly before heating for welding.
Especial care should be taken to have a good fire. The long piece should be placed in the fire so as to be removed with the left hand, and the short one with the right. Place the short piece on the anvil, with the long piece, held in the left hand, on top of and overlapping it sufficiently to prevent any openings. When welded, the long piece should be perfectly straight, with the short one at a right angle to it. Finish the weld with the flatter while it is at a dull red heat. Sketch _D_ shows the T completed.
=80. Chain Making.=—Fig. 60. Bending, scarfing, and welding links. Material required: 8 pieces of 3/8-inch round iron, 6 inches long.
Heat and bend the center of each piece to a semicircle 3/4 inch inside diameter; make the ends of equal length and parallel from the semicircle, as at _a_. Take one of these bent pieces and form a scarf on one end by holding it on the edge of the anvil at an angle of 45 degrees, as shown at _b_, and delivering overhanging blows, as indicated by the dotted circle, which represents the hammer. Turn the link over, placing the other end in the same position as the first, and scarf. Bend both scarfs toward each other equally until they overlap sufficiently to prevent any opening being formed, as at _c_; this is called closing the scarf.
Heat and weld the link by delivering the first few blows on its sides while it is resting on the face of the anvil, then by delivering lighter ones, while it is hung on the horn. While striking the light blows, do not hold the link in a fixed position, but move it to receive the blows around the circumference. The finished dimensions are 2 × 3/4 inches inside; a slight variation in length does not make any difference, but their ends and widths should be uniform.