In the upper square we find +4, enter this in upper square of second column at its full value as shown.

Next we find a "0" in the second square of first column, and as this is a loss of four seconds from the entry shown in the square above we carry it out in second column as -4. In the lower square of first column we find +16 and as this is a gain of sixteen seconds over the square above, it is necessary to carry this to second column at its full value as per illustration.

Rules and Practice for Adjusting Watches — Part 13

To determine the extent of variation between heat and cold, simply ignore the normal rate of -4 in the second column and subtract +4, from +16, which indicates an error of twelve seconds slow in heat compared to cold.

Rules and Practice for Adjusting Watches — Part 13

Or it may be determined as twelve seconds fast in cold compared to heat. For convenience sake it is advisable to form the habit of using one of the temperatures as a unit for comparison and wherever large quantities of watches are adjusted, it is generally the custom to use the higher temperature for this purpose and the rate is stated as either slow or fast in heat. In this instance the rate is slow in heat and it will be necessary to shift one or more pairs of screws toward the cut as explained in Chapter 1, No. 2.

Rules and Practice for Adjusting Watches — Part 13

The rate in the normal period cannot be considered as of any value, its importance consisting only of allowing the metals to return to the natural form and tension before being placed in the cold box.

This is quite important in obtaining a true estimate of the error, because of the fact that in transferring the watch immediately from the extreme of heat to the extreme of cold, there will be a period of time during which the metals are readjusting themselves to the natural form, and the variation in time during this period will not be accounted for, as the real comparative rate will not begin to develop until after the natural form and tension is reached.

If the limit of time devoted to testing is no object and if a very fine rate is desired the observatory method is of course to be preferred. However, by allowing an intermediate day at normal temperature we have the assurance that the hairspring is at the same tension and that the balance has the same form concentrically when the test begins in cold that it had when the test began in heat.